Question about Honda Odyssey

1 Answer

I posted a problem with my 1997 honda Odyssey the other day. Its hatch will not open and I'm not sure how to procede. I do not see any way to take the inside panel off. The hatch still will not open. thanks for you help, Ken

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,

Thanks for contacting Fixya.com
Naturally all door panels have screws in thenm and also push clips that look like christmas trees. Is the door lock knob round or square at the top. Pull it p look for any screws , the door handle might be held on with a horshoe clip you will need to push it off but be carefull because if it does have one it will pop off so catch it. Sometimes little circles in the hard plastic will hide a screw behind them, pop thes eoff also. Will the panel push up now if not get between the panel and the door and pry the panel outwards.Sometimes at the top by the window you have to push in and push up to get it to relase at the window.

Let us know if you have something more to know else please accept the suggestion.
Thank You.

Posted on May 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What s the procedure to change stop light 2006 honda odyssey


Open the rear hatch. The lens assembly is held in place with two 10mm bolts located on the side panel, just under where the hatch closes.

after you remove the bolts the whole lens assembly will pull out and expose the bulb sockets.

Here is a video for a 2007 model. it is the same as yours.

Mar 14, 2015 | 2006 Honda Odyssey

2 Answers

The trunk will not stay open on my 2007 Honda Odyssey? Any idea how to fix this?


there are springs or Shock absorbers attached to the hatch change the shocks or if its attached to a spring either its broken or its loose from either side

Jan 20, 2011 | 2005 Honda Odyssey

1 Answer

Rear hatch will not stay up when opened. The "shocks" will not hold?


Replace the rear hatch shocks. They are weak if they dont hold up the hatch.

Nov 12, 2010 | 2007 Honda Odyssey

1 Answer

I have a 2006 honda odyssey. Recently, I have found water coming from the latch when I open the door and can hear water in the hatch door. I cannot tell how the water is getting in. Any thoughts?


when you wash your car the high pressure water will enter but, drain holes are punched into the bottom of all the doors/hatches and, must not be blocked. Please clean the drain holes.

May 17, 2010 | 2006 Honda Odyssey

1 Answer

My 2002 odyssey van rea hatch door will not


Lift motor or power for it. Check fuses.

Feb 07, 2010 | 2002 Honda Odyssey

1 Answer

Honda Odyssey Coolant System Prob.


You may have air in the system. Run the car with the cap removed and the defrosters on allowing air to escape. Add antifreeze as needed to keep full while running. Fluid level will drop as thermostat opens.

Dec 14, 2009 | 1997 Honda Odyssey

1 Answer

2004 Honda Odyssey EX brake light replacement. How do you remove


open the rear hatch. Next to the brake light assembly, between it and the hatch there are two flap doors in the brake light trim. Take a small flat blade screwdriver and open these doors. The hinge side of the flap is nearest the hatch opening. When opened, the flaps will reveal two screws. Remove these. Then wrap a flat blade screwdriver with some tape (protects the paint) and put the blade at the front outside corner of the brake light assembly. Pry gently rearward and a plastic spear point clip will release. With the assembly off, you can see how to twist out the bulb sockets and replace the bulbs. to replace, put the spear point clip in first, replace the screws, and close the flaps in the trim.

May 30, 2009 | 2004 Honda Odyssey

1 Answer

2002 Honda Odyssey brake light replacement


open the rear hatch. Next to the brake light assembly, between it and the hatch there are two flap doors in the brake light trim. Take a small flat blade screwdriver and open these doors. The hinge side of the flap is nearest the hatch opening. when opened, the flaps will reveal two screws. Remove these. then wrap a flat blade screwdriver with some tape (protects the paint) and put the blade at the front outside corner of the brake light assembly. Pry gently rearward and a plastic spear point clip will release. With the assembly off, you can see how to twist out the bulb sockets and replace the bulbs. to replace, put the spear point clip in first, replace the screws, and close the flaps in the trim.

Mar 05, 2009 | 1997 Honda Odyssey

1 Answer

2003 Honda Odyssey Brake light replacement


open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).

Jan 22, 2009 | 2003 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...