Question about 2001 Mitsubishi Montero Sport 4WD

1 Answer

Fuses are good, bulbs are good, tail light illuminates but not the brake lights help

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 233 Answers

Brake light switch under the dash is out. it is attached the upper part of the brake pedal and anyone can replace this parts without putting in a shop if u have a small tool set flat screw driver and pliers. careful to not break the wiring plug-in clip

Posted on May 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Tail lights work but not brake lights 93 toyota camry

The brake light side of the bulbs is powered by the brake switch and travels thru the turn signal switch.
If the third brake light works, I would guess the problem is in the turn signal switch.

Jul 02, 2012 | 1993 Toyota Camry

1 Answer

Brake lights

Have you checked for a burned out fuse? Tail lights also (typically) have two filaments. One for parking lights and another for when the brake switch near/on the brake pedal is in the on position. This switch is another possible source of your lack of illumination. Reverse lights should/might be on a different bulb. If you have already verified that the bulbs and fuses are good, try changing/adjusting the physical switch at the brake pedal.

Dec 30, 2011 | 2005 Pontiac Bonneville

1 Answer

2003 silverado 1500 ls tail light problem..all lights work turn signals work light on and off work but when i apply brake driver side light fails to illuminate..have new bulbs and have checked...

Check that you have a good earth you may need to remove the earth wire from body of vehicle clean erea then replace if not check that the wire to brake bulb is not burnt out you can do this by using another piece of wire going strait from terminal to bulb or with a test light hope this helps

Mar 03, 2011 | 2003 Chevrolet Silverado 1500

2 Answers

When headlight are on and hit the beake pedal only the 3rd brake light comes on the rest are stuck . When i release brake pedal it seems like i am driving with my brake light on . but my headlight off...

It may sound silly, but check your brake light bulbs to see if they have been installed incorrectly. Brake light bulbs have two filaments, one for tail light, and a brighter one for brake lights. On some cars if the bulb is installed wrong, the brighter filament will stay on for tail lights. The only other thing I can think of is the wrong bulbs have been installed.

Dec 25, 2010 | Toyota Camry Cars & Trucks

1 Answer

I have a 2000 Jeep Wrangler Trouble Symptoms: -When lights are on, brake lights (all three) remain illuminated and only flicker when brake pedal is depressed. Facts: -With lights off, dashboard lights...

sounds like wireing is shorted together. you need to trace down wires and check for bad spots in wireing. also be sure and check plug if you are set up for trailer lights.

Feb 13, 2010 | 1990 Jeep Wrangler

2 Answers

Tail bulbs illuminated on dash panel and glow plug light is on

You may want to check you fuses. If your fuses are good, check you brake light switch.

Feb 08, 2010 | 1999 Volkswagen Passat

1 Answer

My turn signal won't lit when activate and my brake light also wont also but is illuminate. The Top Brake light do light up when press

Check the fuses to the brake lights , All of the signal and tail lights etc. are usually on one circuit. If not, make sure that the bulbs are good and connecting firmly to the plug.

Jan 01, 2010 | 2002 Mercury Mountaineer

1 Answer

94 toyota previa brake lights not illuminating


Jan 08, 2009 | 1994 Toyota Previa

Not finding what you are looking for?
Cars & Trucks Logo

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides