Question about 2002 Nissan Maxima
2002 nissan maxima fast idle adjustmen.
How to adjust ?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The idle speed is computer controled, it is not adjustable, you most likely have sludge in the throttle valve and the idle speed control air bypass valve, clean them with carb spray with the engine running.
Posted on Sep 17, 2008
There are a couple of things that come to mind. One is make sure the EGR Valve and intake manifold are not carboned up. I normally have to clean them every 60 to 80,000 miles. It will actually close up with Carbon and restrict air flow and make the EGR valve malfunction.
Secondly, the diesel pump may just have a lot of wear and it is putting out too much fuel at idle. The only way this can be checked is by the dealer with a VW specific scan tool such as VAG-COM. With this tool, you can go in and look at the the pump timing and start injection quantity.
I have the start injection quantity many times but you have to have the software and login to get the readings. Most dealers will not do this but would rather sell you a pump if it is off.
Remove the hose from the intake where it connects to the EGR valve and look at the inside with a flashlight. See how much carbon is accumulated. This may not solve this problem but will help with starting and performance issues if corrected.
Good luck and hope this helps. To adjust the Idle, it needs to be programed in to the ECM so i am thinking that it's a Carbon issues that is restricting the air flow which the ECM is compensating to keep the engine from stalling.
Posted on May 22, 2009
SOURCE: headlight adjustment
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Sep 30, 2009
Tips for a great answer:
Jun 05, 2015 | Nissan Hardbody Cars & Trucks
Oct 26, 2013 | 2001 Nissan Pathfinder
Jul 02, 2011 | 2000 Nissan Maxima
Mar 06, 2010 | 1990 Nissan Maxima
Sep 26, 2009 | 1991 Nissan Maxima
Aug 29, 2009 | Nissan Minivan Cars & Trucks
Jul 29, 2015 | 2002 Nissan Maxima
740 people viewed this question
Usually answered in minutes!