Question about 1996 Chrysler Town & Country

1 Answer

It starts up just fine and then dies before I can get it into gear. It was running just fine yesterday. Fuel and oil levels are fine.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

Could be a ton of stuff but I'd start with the ASD (Auto Shut-Down) relay

Posted on May 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could issue be when caliber starts fine but dies when put in gear?


it is obvious that under a load the car will not run
first do a tune up and make sure all cylinders are firing,check codes and even do a fuel pressure check

Aug 30, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Sputtered out and now it won't stay running; dies when put in gear.


Mass air flow , crank sensor . I wouldn't discount anything . Having a scan tool that can view engine sensor data would be a great help too , testing fuel pressure and flow and back pressure test the exhaust .
058 Engine Hard to Start or No Start Lean Fuel Condition
055 Engine Hard to Start or No Start Scan Data for EGR
057 Engine Hard to Start or No Start Ignition Module Test
007 Catalytic Converter Testing



Jun 10, 2017 | 1999 Buick Regal LS

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

2 Answers

The car starts fine and runs good but when i come to a stop it will die, but here is the problem it will start right back up but when i put it in gear r,d,1,2, the car will just die again.


Your solenoids inside the transmission may be bad, try to unplug the 4 wire connector to the front of the transmission to see if the problem still continues, if it doesn't then its the solenoids causing the problem, they stay engaged into gear thus car dies and when you put on park, it starts fine again, when you shift it dies again. I had the same problem, changed the all solenoids fix my problem. Hope it helps.

Oct 21, 2010 | 1992 Chevrolet Lumina

2 Answers

98 volkswagon jetta runs fine but shuts down when going to drive


need more info.does it stumble then die.had anyone look at it recent?does it change with ac on?

Aug 04, 2009 | 1998 Volkswagen Jetta

1 Answer

Engine stalls when put into gear, idle fines in park


This is a comon problem with GM cars.Most likely cause is the torqe converter clutch lock up solenoid.

Mar 04, 2009 | 1996 Chevrolet Cavalier

1 Answer

1979 Firebird Esprit hard to start and keep running, dies in gear


it sounds like timing to me if it dies when you put it in gear.it can idle fine but when you put it in gear and it dies then you have timing problems

Jan 13, 2009 | 1979 Pontiac Firebird

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...