Question about 1992 Ford Crown Victoria

1 Answer

I have 2004 Ford Crown Victoria for a month or so now my headlights click and go on and off, when i am driving at night i have to hold the turn signal back like for the bright lights, thats the only way they stay on and then i will hear a click and they will come back on every once in awhile. They do this through out the the whole trip while im in my car on and off all night it is getting very troublsome and pissing me off, or im going to get a ticket from the cops if i cant find out what i can do to fix them someone help me i i love my car and it only has 66,000 miles on it and it makes me very mad about this problem HELP!!!!!!!!

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Replace the headlamp dimmer switch if holding the directional back get these lights working properly

Posted on May 30, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car wont car clicking noise

Have you checked your battery voltage? Do your headlights come on?
Could even be a dead starter. run a test on it with a volt meter.

Mar 14, 2014 | 2004 Ford Crown Victoria

1 Answer

While I'm driving down the highway or street the headlights on my 2005 crown victoria will go out at times and I'll have to hold down the bright light lever on the steering wheel to have...

Headlight fuse Should be in the fuse box under the hood. should be close to the battery. Should be 2 headlight fuses 1 for ea side
hope it can help you if it can't i think you need an auto tool and you can found here:

Nov 12, 2012 | 1989 Ford Crown Victoria

1 Answer

Headlights go off but signal and tail lights stay on.

The lighting control module is defective and needs to be replaced...A well known defect. I know. I just researched this and replaced mine due to headlight outages. There is extensive information on the web regarding this dangerous defect. The NHTSA conduvcted an investigation and closed it.......No recall on the defective part. You wanna drive your Crown Victoria 2003-2005 at night?..........Pay money and replace the LCM.

Aug 19, 2010 | 2003 Ford Crown Victoria

1 Answer

Replace 2004 Crown Victoria headlight

From the engine compartment, unlock the 3 tabs that are over the headlight housing area. Remove the cover and unscrew the plastic ring that has the wires protruding from it. Carefully pulls the light fixture out of the housing. Pull the 2 L-shaped tabs up and remove the lens section. Reverse the steps to re-install the headlight. If replacing the full turn signal housing, unscrew 2 screws from each light , disconnect bulb wiring and remove. Replace accordingly.

Jul 23, 2010 | 2003 Ford Crown Victoria

2 Answers

2004 Crown Vic- Headlights come on when first started and stay lit. Once driven 20 minutes and shut off; they may fail to come on or come on and then go out. Using the 'flash' wand, the high beams will...

There is a resistor in the light control module under the driver side of the dash. You can replace the whole module which is about 100+ dollars or if you're good with soldering, replace the resistor. You will need to remove the box and open it up. Find out the resistor part number and replace it. This is a common problem on the 03-05 crown vics. Good luck

Mar 03, 2010 | 2004 Ford Crown Victoria

1 Answer

Headlights wont dim but work when clicked on bright

Replace both low beam headlights. It's common to have one headlight burned out and you may not realize it for months. Then the other one goes out and "puff" you have NO low beams.

Feb 20, 2010 | 1990 Ford LTD Crown Victoria

1 Answer

What tool can you use to take out the headlight assembly on my 2002 ford crown victoria?

no tool is needed.Just pull up on the l-shaped metal tabs that hold the plastic "screws" in place then take the tabs off then remove the headlight assembly.

Jun 13, 2009 | 2002 Ford Crown Victoria

3 Answers

Headlights quit working on my 2001 Ford Crown Victoria Police Int

It needs a new headlight switch assembly. A parts worn out inside. The approx. cost for a new one is abot $160.00. Sorry.

Dec 26, 2008 | 2001 Ford Crown Victoria

4 Answers

Headlights turn off while driving

Headlight module under the dash. It is the size of a box of crackers, not a small part.

Dec 15, 2008 | 2005 Ford Crown Victoria

3 Answers

Headlights wont stay on

LCM is bad. Do not buy used one - they all have problems. Rebuild service available, email to

Dec 08, 2008 | 2004 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides