Question about 2000 GMC Jimmy

1 Answer

Fuelpump went out on the jimmy now it wont start.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Bang on the fuel tank to get it going, then replace it but check feul pump relay first

Posted on May 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Running fine. Cruising about 55. Died. Why won't it start?


Theres hundreds of reasons that a vehicle wont start.The Jimmys and blazers are known for bad fuelpumps, you can start there

May 12, 2015 | 1998 GMC Jimmy

1 Answer

Starts but wont rev up


did you replace the fuel regulator located on top of the fuel pump?

Feb 12, 2013 | 1996 Jeep Grand Cherokee

2 Answers

I have a 1995 gmc jimmy. When I purchased it (used) the check ingine light was on. I was told that it was checked out but there was no problem with the vehicle light was just on (bull). The vehicle ran bad...


Try replacing oil pressure switch. Your oil pressure switch controls fuel pump. (safety issue) in case of roll over or accident so fuel pump doesn't run while engine stalled or of.

Feb 24, 2011 | 1995 GMC Jimmy

1 Answer

1999 gmc 4.3 jimmy 4 weel drive, service engine light on, will not start


The first thing i would do is have the computer scanned for codes and see what codes are stored, you may have a bad fuelpump or a control module problem, check for fuel and spark, spray starting fluid into throtle and see if it starts if it does then you know its a fuel problem.

Oct 08, 2010 | 1999 GMC Jimmy

2 Answers

My vehicle won't start. first few times i would let it sit for about 20-30min then it would start. then it went to a few hours. now it just wont start at all. What could be the problem? please help.


Change the fuel filter. It's probably blocked. It is usually located passenger side ahead of the wheel well along the frame rail. Hope this helps. Good luck!

Aug 14, 2010 | 1996 Plymouth Voyager

3 Answers

1997 jimmy turns over but wont start


the first thing to check is spark and fuel,remove a sparkplug boot and spin engine see if it sparks and then check for fuel preasure,if theres no fuel it may be a bad fuelpump, if theres no spark then that may be a bad control module in the distributor.

Mar 02, 2010 | 1997 GMC Jimmy

1 Answer

My 1999 gmc jimmy will not start unless i use starting fluid


u may want 2 check with a dealer gmc dealer but u may have 2 fuel filters on your jimmy poss. an in-line filter runs down the pass. side or driver side not all cars are the same

Apr 25, 2009 | 1999 GMC Jimmy

1 Answer

2000 gmc jimmy wont start fuel pump comes on and cuts off but will not start.I have changed the fuel filter and that did not work. Is the pump not building the pressure it needs to start or would my...


the fuel pressure if leaking could cause this the regulator is located under the intake plenum but you should smell gas .if you dont then most likely the pump is bad ,the pump will come on for 2 seconds when the key is on then go off it will not stay on with just the key on only when you crank it will it .so have your fuel pressure checked with a gauge.

Mar 22, 2009 | 2000 GMC Jimmy

1 Answer

Fuelpump switch wont turn on


Look in the trunk on left side you should see a square hole in the trim panel with a label you will see a button on top of a black switch push the button on top.

Feb 22, 2009 | 1996 Ford Crown Victoria

1 Answer

1997 jimmy wont start


check your stater wires

Jan 05, 2009 | 1997 GMC Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...