Question about 2001 Dodge Neon

1 Answer

2001 DODGE RUNS FOR AWHILE,THENS CUT OFF,IT WON'T CRANK BACK TILL BATTERY IS DICONNECTED,AND SITS AWHILE.I HAD THE ENGINE LIGHT CHECKED THE CODE WAS P1391.

Posted by on

  • Dan
    Dan May 30, 2010

    Have you tried jump starting it?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 373 Answers

The code p1391 is telling you that your ckp/cmp sensor signal is lost. What it is saying in normal terms is that the (crankshaft position sensor and the camshaft position sensor) are not sending a signal from time to time. That is why the car cuts out and will not start. First thing is to look at both sensors and check the wireing to each for any damage. The ckp is located on the front of motor on bottom side. The cmp sensor is located on the back of engine near the top. You have either one or both sensors that are not giving a signal to the pcm (power control module ). Hope this will help.

Posted on Jun 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2001 gmc sonoma has code p1621 control modle long term menory perfprmace what is the fix for this code


I would disconnect the battery for a few min then hook it back up to see if it resets itself. if not you have bad cell in the battery and needs to be replaced. good luck

Dec 07, 2013 | 2001 GMC Sonoma Extended Cab

2 Answers

2001 dodge 5.9 cummins quit going down the road check engine light came on it cranks over but won't start


sounds like a injector pump to me had a 99 dodge cummins went through three of them in 350000 miles done just like you are describing.

Aug 21, 2012 | Cars & Trucks

1 Answer

2001 ford taurus car starts fine drive it for awhile then shut it off and it wont start let it sit and it will start battery is fine


Does it crank?If you shut it off and you restart after a few minutes and it cranks but won't start or starts and runs rough the injectors are leaking and flooding the engine. Need better description

Dec 07, 2011 | 2001 Ford Taurus

2 Answers

My 2001 Dodge Durango won't start at times. I replaced battery and had alternator checked. Both checked out fine?? Help! ??


When it won't start, will the engine turn over and try to start, or does it act like a dead battery?

Jul 14, 2011 | 2001 Dodge Durango

2 Answers

P1493 code


If you are running any extra systems, ie amps, subs, high watt speakers, etc. etc. you may need to get a better batter, like the blue. or yellow top one. check with auto zone.

Mar 11, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

Engine light on - Dodge Grand Caravan Sports 2001


p1684 means the battery was disconnected within the last 50 starts!!
this means that the light should go off, if it continues to set that same code i believe it's because the battery voltage is too low!!
so buy a new battery and that should fix your problem!!:-)

Jun 18, 2009 | 2001 Dodge Grand Caravan

1 Answer

2001 intrepid first problem oil light flickers when gas is accelerated. drove on freeway accelerated gas to catch speed and had to come up once came up it cut off on me and would not start back up. just...


the flickering oil light is a common problem with the 2.7 engine. as long as the oil level is full and oil is changed regularly, and the light just flickers and doesnt stay on , shouldnt be a problem, or get the oil sending unit changed. the second problem car stallings sounds like either cam or crank position sensor. does the engine light come on. if so the code should tell you.

Mar 19, 2009 | 2001 Dodge Intrepid

Not finding what you are looking for?
2001 Dodge Neon Logo

627 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...