Question about 2008 Honda Pilot

1 Answer

2008 Honda PIlot a/c cabin filter

Instructions on replacing filter.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Try looking for the big tube its ribbed leads to a box open the box and you will find your filter just replace it with the new one the same way you took the old one out.

Posted on May 29, 2010

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2008 honda pilot cabin air filter

This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The indicator light is on and it's a B 12. Honda Pilot 2008. The book says air filter, etc Any ideas?


Time to maintenance... B12 just means an oil change and inspection (B), tire rotation (1), and replacing the air cleaner element/dust & pollen filter/inspect drive belt (2).

Hope helps (remember to rate this answer).

Apr 28, 2011 | 2008 Honda Pilot

2 Answers

I am looking for info on how to replace the cabin air filter in a 2008 Scion XD, a how to guide or instructions. I replaced the cabin filter in a Subaru and Mazda.


instructions should be in your owners manual. generally you remove the glove box and remove a plastic cover for air filter. Pull out filter, noting the direction of flow on the filter, push in the new filter and button everything up.

Oct 28, 2010 | 2008 Scion Xd

1 Answer

How to change cabin air filter honda pilot 2007


1.remove the glove box. 2.Cut the plastic cross brace in the glove box opening with diagonal cutters in the area shown, and discard it. 3. Remove the bolts, the srews, and the glove box frame. 4. remove the filter lid from the evaporator, then pull out the dust and pollen filter.

Jun 20, 2010 | 2007 Honda Pilot

4 Answers

Where is the cabin filter on a 2003 honda odysseey


The cabin filter is located behind the glovebox.
First lower and remove the glovebox
If it has not been changed before, you will need to cut the plastic crossbrace behind the glovebox.
Once out of the way, unbolt the steel reinforcing frame behind the plastic and set it aside.
The cabin filter is mounted vertically behind it.
See images for further explanation:

51b70ba.jpg
645c9b6.jpg
27573b7.jpg

Feb 26, 2010 | Honda Odyssey Cars & Trucks

1 Answer

Hi Having trouble removing cabin air filter on a 2007 honda pilot


Remove the four screws on the air filter hood (driver side, behind battery) using 5/16" socket. No need to remove screws all the way. Lift plastic hood just enough to reach air filter. Electrical connector can remain. Slid out old air filter. Insert new one. Replace hood, and tighten the four screws.

If the filter is tight, wiggle it left-right when pulling the filter out.

Dec 05, 2009 | 2007 Honda Pilot

2 Answers

2008 honda pilot cabin air filter


This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.

Aug 24, 2009 | 2008 Honda Pilot

1 Answer

Air/Cabin filter Maintenace


Simple! No tools needed! Take everything out of glove box. Squeeze sides in until glove box can swivel down. You will se a black cover that has arrows on it showing the direction of air flow. Squeeze the side latches on that cover and it slides right out. The casing is "keyed" so it will only go back in one way. If you can read the wording on the cover, you have it right.

Jun 02, 2009 | 2009 Honda Pilot

1 Answer

How replace a cabin filter?


remove two screws to glove box take it out completely and saw offf plastic bar in front of filter(it is only a molding bar for dash bar set-up not needed) then pull out cabin filter and replace and then screw in glove box compartment

Jul 23, 2008 | 2005 Honda Pilot

1 Answer

Cabin Filter replacement


The filter comes with the instructions. I just did it last night to my Honda. It is behind the glove box. You need to remove the glove box, cut a plastic beam out, unscrew the metal support beam and then open and r/r the filter. The instructions don't mention that you need to remove the trim that covers the little fuse box located on the side panel--there is a plastic retainer that you unscrew by hand and then it all comes off easiliy!

Jul 23, 2008 | 2005 Honda Pilot

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...