Question about 2003 Nissan Pathfinder

Open Question

My Nissan 2003 Pathfinder, has a acceleration problem, while i am driving in slow speed, its shake, I can't press the gas pedals

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 491 Answers

SOURCE: Car shakes really when I accelerate from any speed

i would check your motor mounts and transmission mount. sounds like one if them is going bad

Posted on Nov 16, 2008

  • 62 Answers

SOURCE: sputturing engine

have your spark plugs, coil pack boots checked for moisture,on many ford water will accumulate around plugs,expeually if it has rained recently.

Posted on Jan 13, 2009

johnthejag
  • 286 Answers

SOURCE: rattle when accelerating

Hi
Classic sound of pinking !
Possible dodgy fuel ?
Check for possible air leak.
Good Luck !
John.

Posted on Jan 15, 2009

  • 3 Answers

SOURCE: 1995 nissan pathfinder

You'll probably have to change the clutch plate on the flywheel. You'll have to get a floor jack, but a transmission jack is easier to remove the transmission. To remove the transmission you'll have to remove the tortion bars on both front wheels. Also, you'll have to remove the crossmember aft of the transfer case. You'll also have to remove the front and rear drive shafts. The manual says you should keep the transfer case from leaking oil out the back. but, you can just top it off after you're done. Be careful not to damage the seal seal for the rear drive shaft. Anyway, once you get the transmission and transfer case out (you'll have to remove the shift and transfer case levers), you should have enough space to remove the clutch plate from the flywheel on the engine. You should have an alignment tool to make sure the clutch plate is aligned with the crankshaft so you can put the transmission back on.

Posted on Feb 06, 2009

  • 2 Answers

SOURCE: rattle when accelerating

had the same issue, had someone look and it seems the noise was caused by heat shield being loose covering exhaust system. Have that checked out.

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code 1700


Check your Speed sensor, Idle air control valve, then check your Accelerator Cable that attaches to the back of your (gas pedal) going to your throttle body.

May 17, 2013 | 2003 Nissan Murano

1 Answer

At slow acceleration the car starts skipping


use a couple of cans of injector cleaner as faulty injectors are indicated

Sep 09, 2017 | Cars & Trucks

1 Answer

92 NISSAN WITH BOGGING AT 2800 3500 RPM AND AT LEVEL SPEED 4CYL AND 5 SPEED


For this types of problem,there are few help inks to troubleshoot the problem.Click the link below to go through the troubleshooting procedure to resolve the issues :----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------van idles rough? http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html
--------------runs lean and idles rough? http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html
-----------Car still runs Rough after tune up? http://howtobyme.blogspot.com/2011/12/car-still-runs-rough-after-tune-up.html
------------Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed? http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
----------High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
------------Engine Backfires? http://technoanswers.blogspot.in/2012/02/jeep-backfires.html----------- Nissan stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

-----------
Nissan Pathfinder Backfires? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-backfires.html
---------How to adjust rpm? http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
------------Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html
----------This will help.Thanks.

Feb 17, 2012 | 1992 Nissan Pickup

1 Answer

I have a 1995 pathfinder that keeps stalling on me when I start slowing down


Mine did the same thing. We cleaned the throttle body and poured Sea Foam, a gas treatment, in the gas tank... also check the air filter while you are at it. worked for me.

Nov 28, 2011 | 1995 Nissan Pathfinder

1 Answer

03 altima gas pedal regulator switch


Not gas pedal regulator switch . It's 2003 Nissan Altima Accelerator Pedal position Sensor Has to do with the electronic throttle control .
2003 Nissan Altima Accelerator Pedal Sensor

May 07, 2017 | 2003 Nissan Altima

1 Answer

Nasty vibration on the floor under the gas pedal


check the drive shaft between the intermediate transmission and the front transmission for miss alignement and defectivness of the telescopics system of this shaft. we had about the same problem on our 1996 same model...

Feb 25, 2009 | 1995 Nissan Pathfinder

Not finding what you are looking for?
2003 Nissan Pathfinder Logo

Related Topics:

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...