Question about 1993 Ford F150 SuperCab

Open Question

My steering box is leaking on my 1991 F150 4x4 supercab. How do I change the seal?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: QUESTION ON A 1992 FORD F150 SUPERCAB TRANSMISSION

There is only 1e40d for all 5.8 windsor transmissions ,so I got a used one off a van. Auto zone is wrong by offering 2 types, one for the supercab and 1 for the regular.

Posted on Jun 02, 2008

  • 92 Answers

SOURCE: how toreplace rear main seal in 92 F150 4.9 inline 6

A- you will have to drop oil pan,then remove rear bearing cap.they market a chinese finger that can install in the upper chanber, seat lower half in cap groove install cap . bolts finger tight, then torque, both bolts evenly as you can until done to manufactures specs.

Posted on Oct 05, 2008

  • 57 Answers

SOURCE: power steering leak

check the lines going into the power steering unit

Posted on Apr 23, 2009

heavymetal77
  • 721 Answers

SOURCE: rear axle leaking

Block the front tires. Break the rear lugs loose. Jack up the rear of the truck at the center if possible. remove the wheels & brake drums. Remove the brake shoes,return springs & all the other hardware. Remove the differential cover & drain oil. If you have a posi the next step sucks. You need to remove the threaded pin from the housing & remove the axle retaining clips. All the while,being carefull of the spring in the posi unit. If no posi,then same procedure,minus the "pucker factor". After the axle is out,take a large flat blade screw driver or pry bar & pop the seal out. Keep in mind the axle bearing is probably gone too , so that's another procedure. Keep it apart,you'll be glad you did.

Posted on Jun 23, 2009

  • 1779 Answers

SOURCE: where is the in cab air filter located in my 2003

Wow, that's a great question, as I researched it, I found listings of cabin air filters at some parts suppliers, but could find no reference to location or info in the original owners manual. So, what I found is that it was a dealer add on option, not standard equipment or a factory available item. If you have the dealer add on, it should be located under the dash glove box, but you most likely don't have it. The kit # if you want to add it is the following Ford part #, but it may not be available, and check w/ Ford to make sure it will fit your year, model, as I got this # off the internet, and haven't checked it at the Ford website:F65Z-18D477-AA. Good luck!

Posted on Sep 08, 2009

Testimonial: "Thanks for your help. The auto parts store mentioned that there were 2 filters but did not mention that they were an option on my truck. Thanks again"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a leak in my steering gear on my 2003 chevy silverado


Steering Rack --you replace,they are not serviced for seal leaks

Steering Box--- I doubt you have --comes out & be worked on
The pitman nut & arm comes off & you replace the sector
shaft seal at the bottom

Dec 01, 2012 | Cars & Trucks

1 Answer

Steering fluid leak; oil covering steering gear box


if the leak is coming from the steering box there are usually only 3 places it can come from;most common place is the pitman shaft seal,which can be replaced.this is were the pitman arm of the steering connects to the steering box.another place is the steering box input shaft seal,this is were the steering colume connects to the steering box,which can be replace.the last place is the power steering hoses were they connect to the steering box.there are seals that seal the lines when screwed into the box which can also be replaced.so first you need to see exactly were the leak is coming from.rare occasions the steering box is porous which means the box will need replacing.a car of this age should have shown up long ago.you will have to clean the box off at the car wash then run the car and turn the steering wheel all the way to one side,this will build up pressure in the system to show up the leak quicker.

Apr 04, 2012 | 2000 Jeep Wrangler

1 Answer

The steering box on my 93 astrovan is leaking


your going to need a steering unit replacement. Go to orielly.com auto parts and look up to see if there is seal. But I doubt it. We never replace seals in steering gears.

Jul 19, 2010 | 1993 GMC Safari

1 Answer

Power steering leaking. In what areas does leaking occur?


the two most common are the High Pressure power steering hose and the power steering pump shaft seal.

May 10, 2010 | 1991 Honda Accord

1 Answer

How to fix oil leak from top of a manual gearbox housing


sorry but its going to be a big job. you need to remove the gearbox to open up and get to the seals. you could try and use an additive in the gear box, its like oil seal for engine you can get it for engines gear boxes and difs and power steering. it sometimes goes by seek and seal, in older vehicles its quite good. you will need to replace the oil it will need to be done twice to clean it all out so it can get a good seal.. i.e change oil run engine get the gearbox to move for 20 min then change the oil as its warm not hot so let it cool down for 10-20 min then drain. put the seek and seal in and top up with oil and run as normal, check after a few days to see if its worked. usual does.

Jun 12, 2017 | 1995 Ford Ranger Supercab

1 Answer

What would happen if the lower sector shaft seals were damaged


Are you refering to the seal on the bottom side of the steering gear box? The side the pitman arm connects? If the seal is damaged and leaking you can run out of power steering fluid which in turn could rouine your power steering pump and steering gear box.

Sep 28, 2009 | 1994 Ford F150 Styleside Supercab

3 Answers

Power steering leak on a 1988 full size bronco


The gear box is a common problem on this model. That would be the place I would start. A cheap, temporary fix is to go to your local parts store and ask for Lucas Power Steering Stop-Leak. It will buy you some time.

Apr 09, 2009 | 1988 Ford Bronco

2 Answers

Power steering gear box


The seals can be changed, they sell a kit, but u will have to remove the box to do that.

Oct 18, 2008 | 1994 Ford F150 Styleside Supercab

2 Answers

Power steering gear box leaking at steering column to gear box


I just found 1 of my power steering leaks in my 1990 toy pickup. My high pressure line has a hole in it. I used a florecent die kit to locate the leak. You can get it at Autozone. 

Aug 16, 2008 | 1991 Toyota Pickup

Not finding what you are looking for?
1993 Ford F150 SuperCab Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...