Question about 1985 Lincoln Town Car

1 Answer

Tail light cover removal? How do you remove the covers for the tail lights?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 270 Answers

HI: To remove the Lens for your Rear Lights ,Just remove them from inside your Trunk: You'll Proball Beable to See The Hold Down Studs and Nuts Holding them In Place By Removing some of your Trunks Interior Linings In and Around Where your Tail Lights Are Mounted.Just Remove only the Interior Panels To Expose Your Access To Removing Your Tail Light Lens/Or Covers. Hope This Helps you Let Me Know By Voting For me. Thanks the WYOCWBOY

Posted on May 29, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2000 Ford 150 Truck

Unscrew the light covers and you will see the bulb.

Posted on Jul 18, 2008

  • 45 Answers

SOURCE: remove passenger tail light

I have not yet worked on a Pilot, but from experiance, a lot of tail lights are pulled from the inside and not the out. You may check to see if it comes out from the trunk and not straight off the back from the outside.

gabenevins, a lot of places are selling the entire assembly and not just the lens. I would continue looking until you find just the lens unless you want to buy the whole piece. I do not know what the cost difference is. Perhaps pjpc might be able to tell you where to get just the lens.

Posted on Nov 13, 2008

philschneide
  • 448 Answers

SOURCE: The interior dome light is burned out, removing cover problem.

You will have to pry off the lens CAREFULLY using a small screwdriver. There are two little plastic protrusions on each long side of the lens which fit into the casement. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Posted on Oct 23, 2009

  • 28 Answers

SOURCE: How do remove the rear lens cover on the tail

The lens covers dont come off. You can access the bulb from inside the trunk. By opening the panels

Posted on Feb 08, 2010

  • 1 Answer

SOURCE: how to replace rear turn signal light bulb

I just changed my rear turn signal. Really easy. There is two 1/4 inch bolts visible when you open the tailgate. Take both of those out and gently lift the light housing out towards the outside of the vehicle. There is two small clamps on the other side of the fixture that just slide right out when you pull on it. There you go

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the tail light lens cover for a 1987 Nissan Pickup truck


You can't remove the lens cover. The tail lights are molded as one piece. If you want to change the bulbs, there should be an access panel inside the truck box right behind the tail lights that gives you access to the bulbs. There are also screws to remove the entire tail light assembly if it needs replacing.

Sep 05, 2011 | 1987 Nissan Pickup

1 Answer

How to change a light bulb of a tail light


Remove the tail light cover from inside the van, pop the cover first, then remove the socket by turning it left about hlaf a turn, it will pop out, remove the burned bulb, replace with new one of same type, assemble back reverse of removal.

Good luck.

Aug 20, 2011 | 2001 Dodge Grand Caravan

1 Answer

How to change a tail light


1. Remove the two screws at the outside back of the tail light cover
2. loosen the tail light cover from the two clips at the front of the cover by gently prying it toward the rear. Fingernails worked for me. The bottom clip seemed easier. If it is too tight, try a screwdriver near the bottom, then near the top prying toward the rear of the car.
3. the top light is the backup lamp (white), and the bottom light is the brake/turn/rear light (red).
4. rotate the lamp 1/3 turn to remove and replace.
5. test.
6. replace the cover by aligning the screw holes then pushing the cover into the clips and replacing the screws.

Oct 16, 2010 | 2005 Ford Freestyle

1 Answer

2001 Ram 1500 Truck 2WD: how do you remove a tail light from a 2002 dodge r...


There are for Philip screws holding your tail light cover onto your dodge. Step 1: Just remove those screws and pull the cover off. Step 2: Remove the light bracket out of the cover and replace with a 1057 bulb.

May 18, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Changing the tail light cover for 2003 town and country minivan


There really is no way to change just the cover. Open the hatch. There are two quarter sized round plastic clips that have to be gently pulled out. Then you can remove the tail light.

Feb 04, 2010 | 2003 Chrysler Town & Country

1 Answer

How do I replace my tail light bulbs on 1990 LeSabre? How do I get into the assembly to get to the bulb?


OPEN TRUNK LOOK WHERE TAILS LOCATED LOOK FOR LARGE PLASTIC WING NUTS.REMOVE THEM PULL TRUNK LINER AWAY ENOUGH TO REMOVE THE OTHER PLASTIC WING NUTS HOLD THE TAIL LIGHT COVER.WHEN YOU REMOVE ALL THE PLASTIC WING NUTS THE TAIL LIGHT COVER WILL COME OUT ENOUGH FOR YOU TO REMOVE THE BULB.

Nov 02, 2009 | 1990 Buick LeSabre

1 Answer

Changing tail lights?


open trunk if lights on trunk you have a opening you can see the light electrical connector .if lights on lower part of trunk.remove large plastic screws. pull back trunk lining .you will see some more long plastic wing nut screws.remove them and the light cover come out then you replace light bulbs.

May 01, 2009 | 2003 Nissan Altima

1 Answer

Tail light assembly


If you look inside the trunk, you will need to undo the panel inside trunk to gain access to the bolts that mount the tail light assy's.

Jan 09, 2009 | 2002 Nissan Sentra

2 Answers

How to replace tail light


First you need to lift the hatch. There are two screws under plastic caps. Remove the caps and you will be able to unscrew these screws. Carefully using a flat screw driver to pry out the tail light assembly. It have to plastic pin that attached to the car body. do not break the pin. After you pry out the tail light assembly, you will be able to replace the light bulb. Replace everything in a reverse order.

Nov 17, 2008 | 1999 Lexus RX 300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...