Question about 2002 Ford Escape
It's located in the spare tire compartment in the rear of the vechicle on the passenger side under the foam liner.
Posted on May 28, 2010
By mistake put ethonal 85 in ford escape 2002 , engne light came on , care ran fine, have since refueled will the engine light go out on its own after a while,
Posted on Jun 05, 2011
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off
Posted on Jan 05, 2009
SOURCE: WONT STAY RUNNING
engine dies each time I raise foot from excelerator or have to let up on it to make a stop or slow down, have to push into neutral and restart engine.......
Posted on Nov 14, 2008
Try this web site. It takes you to Auto Zone "How To" site. This one covers the 4 cylinder as you did not indicate the engine size.
Good luck and hope this helps.
Posted on Apr 20, 2009
SOURCE: 2002 ford escape tie rod squeaks
My outer tie rod did the same thing when just out of warranty. I could tell it was "bad" by putting my hand on the tie rod while someone else turned the steering a little and I could easily feel the vibration.
Check the other side to feel the difference. Tie rods don't cost that much, if you can replace it yourself, and take a chance on foregoing the wheel alignment. Maybe a $150? job at the shop.
In my case, a tie rod was not readily available. I verified that it was a good joint; no shake or rattle. Then I squirted a little WD40 inside the boot, and put it back together. 70,000 miles later, the new tie rod is still on my shelf waiting for the squeak to return.
Posted on Mar 17, 2010
Tips for a great answer:
Jul 21, 2016 | 2002 Ford Escape
May 13, 2015 | 2014 Ford Escape
Aug 26, 2014 | Cars & Trucks
Jul 20, 2014 | 2002 Ford Escape
Sep 23, 2012 | 2002 Ford Escape
Mar 15, 2011 | 2001 Ford Escape
Jan 09, 2011 | 2002 Ford Escape
This switch is located in the front
passenger's footwell, behind a
flip-up cover, by the kick panel
To reset the switch:
1. Turn the ignition to the off
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
4. Turn the ignition to the on
5. Wait a few seconds and return
the key to the off position.
6. Make another check for leaks.
Oct 22, 2010 | 2001 Ford Escape
373 people viewed this question
Usually answered in minutes!