Question about 1992 Oldsmobile Ninety Eight Regency

1 Answer

Problem with the left rear air ride shock

I havea problem with the left rear air ride shock absorber. can you put regular shocks on and eliminate the air ride?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,309 Answers

You will have to reconfigure the rear suspension, best talk to a spring and suspension shop

Posted on May 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van shimies left and right badly....and it pulls to the left....it does it more when going straight and not so much when going around curves


check the vans rear shock absorbers if they are faulty the car can exhibit this type of behaviour and braking will be less efficient. Also tyre wear will be affected to.
I am not a shock absorber expert but had recently my four shock absorbers replaced as the fluid had ruptured in the front shockers and the rear mounts for the rear shockers were corroded and unsafe. (shock absorber expert at repair place mentioned the symptoms you are describing as a rear shock problem or the rear leaf springs are faulty)

Mar 18, 2015 | Cars & Trucks

2 Answers

1999 lincoln navigator rear suspension loud bang when going over speed bumps also rear rides higher than front? Compressor is fine all air hoses are fine front air shocks 1 year old rear shocks 1 year old...


Check your rear shocks. On the fender, push with your body going down. Upon releasing, your car should go up and down one time then settle. If it goes beyond or hesitate to move, you have a problem with your shocks. I think you also have a problem with the shock absorber bush. It does not matter if you have a new or old shock absorber. The lifespan of the shocks depends on the way you drive on bumpy roads.

Mar 16, 2014 | Cars & Trucks

1 Answer

Can I replace my air ride shocks on the back of my 96 explorer with regular shocks and do away with the air ride? I need new shocks and don't want to invest alot of money on an old car.


Yes, you can just put regular shocks on the back,just make sure you get shocks that have the same length as your original ones and that are from a explorer without air suspension.That way you wont have the back end of the car riding too low or bottoming out.

Aug 17, 2011 | 1996 Ford Explorer

1 Answer

Need new struts on rear, Would like to replace with air shocks. Any suggestions on how I would do this?


Shock Absorber -The rear already has air shocks on the 1999 Cadillac Deville: REMOVAL & INSTALLATION Rear
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    • Rear wheel Fig. 1: Exploded view of the rear shock absorber mounting 9300vg06.gif

    • Negative battery cable
    • Shock absorber electrical connector from the rear suspension support, If equipped
  3. Support the lower control arm with a jack to relieve the tension on the shock absorber.
  4. Remove or disconnect the following:
    • Lower shock absorber mounting bolt and nut
    • Upper mounting nut, retainer, and insulator
    • Shock absorber compress by hand and remove through the upper control arm
    To install:
  5. Position the top of the shock absorber with the insulator attached into the suspension support.
  6. Install or connect the following:
    • Upper shock insulator, retainer and nut. Torque the nut to 55 ft. lbs. (74 Nm).
    • Shock absorber lower mounting nut/bolt. Torque the nut to 75 ft. lbs. (102 Nm).
    • Shock absorber electrical connector to the rear suspension support, if equipped
    • Rear wheel
    • Negative battery cable
prev.gif next.gif

Jul 29, 2010 | 1999 Cadillac DeVille

2 Answers

What is service ride control


Service Ride Control means one or some of your shocks or struts are worn and may need replacing. The price for new ones is not cheap,

Jul 13, 2010 | 2006 Cadillac Escalade

3 Answers

Right rear air ride shock leaking bad want to know if i can raplace with regular shocks


Yes you can replace with regular shocks. You will want to remove the fuse so the pump no longer runs and you will be OK.
Good luck.

Nov 11, 2009 | 1992 Buick Park Avenue

1 Answer

I think my front/end ride is not as soft as it should be,a month ago my rear left and right control arms were replaced because they were making noise.Also my right rear shock absorber asy was replaced.Any...


have front suspension checked that truck has air suspension, should be half decite ride, some have shocks in the front maybe those are bad,good luck.

Nov 01, 2009 | 2004 Lincoln Navigator

1 Answer

I need shocks, they have never been replaced in 107K miles. Does this car have 4 shocks or 2 shocks and 2 struts


Thr front will be MacPherson struts, a shock absorber surrounded by a coil spring looking set-up.


FOR THE REAR:
If you have front wheel drive and you have Electronic Ride Control (ERC), then the rear suspension has "super lift air shocks".

If you have all wheel drive, then you have struts in the rear suspension.

Does help any?

Oct 26, 2009 | 1993 Oldsmobile Cutlass Ciera

1 Answer

Are their any speical problems or tricks in replacing air adjustable rear schocks on a 2001 buick custom


Removal & Installation

  1. Remove the tire and wheel assembly.
  2. Support the control arm with a jack stand.

    0900c152802427b0.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Use support bracket tool J-23028-01 mounted on a jack to support the rear lower control arm
  3. Remove or disconnect the following:

    Electronic Ride Control (ELC) air tube from the shock Two bolts securing the shock to the control arm Trunk trim to gain access to the shock upper mounting nuts. Cover, the two nuts, and the reinforcement from the top of the shock Shock from the vehicle

    0900c152802427e1.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Remove the cover to gain access to the upper shock absorber mounting components-rear suspension


    0900c152802427e2.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Exploded view of the lower shock absorber mounting to the knuckle assembly-rear suspension


To install:
Install or connect the following:

Shock, reinforcement, and the two nuts. Tighten the mounting nuts to 15 ft. lbs. (20 Nm). Shock cover Trunk trim Shock-to-control arm bolts and tighten the bolts to 18 ft. lbs. (24 Nm) ELC air tube to the shock. Tire and wheel assembly

Apr 09, 2009 | 2001 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...