Question about 2000 Dodge Durango

1 Answer

Where do i put freon on a 2005 dodge durango 4.7. can not find valve

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 196 Answers

The valve should be right on the A/C line that attaches to the compressor. Run your hand along it and see if some yahoo at the factory installed the line with the valve pointing down instead of up. It should be on the silver/metal section of the line.

Posted on May 28, 2010

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 116 Answers

SOURCE: egr valve dodge durango

if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

Posted on Apr 24, 2009

ZJLimited
  • 17970 Answers

SOURCE: EGR Valve 2005 Dodge Durango

Check in the drivers side rear of engine take off the air housing and use 13mm. deep socket w / 3inch ext. and air ratchet to remove 2 bolts, then take tire off inner splash panel then 8mm wobble w / 24inch ext to take 1 tube bolts loosen other one and pull out as ***. Reverse to install.

Hope this help to solve it (remember rated this post).


Posted on May 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the evap on a 2005 dodge durango


The purge valve is up on the engine. the vent valve is by the gas tank or at the charcoal filter, the lines run from the tank and filter to the engine. the lines are plastic, except under the body, metal then. Codes would be nice. This would tell me where to look.

Nov 13, 2014 | 2005 Dodge Durango

1 Answer

How to add Freon to 2005 dodge Durango 5.7L HEMI V-8


This is one thing I insist people have a technician do. If you do not do it correctly two things will happen -- damage to the compressor and damage to the environment. First you need to have the CORRECT grade of Freon, and you need the access tool kit to make the connections and you have to have the correct volume of Freon.

Oct 08, 2014 | 2005 Dodge Durango

1 Answer

Where is the rear expansion valve located in a 2005 durango


I believe it is located on the passenger side firewall.

Apr 19, 2014 | 2005 Dodge Durango SLT

1 Answer

How to replace the egr valve on a 2005 dodge durango 5.7 hemi


Dont bother just make a seal off gasket from a coca cola can ,it will run better without the EGR valve and still pass the emmisions test with it blocked off

Apr 25, 2011 | 2005 Dodge Durango

1 Answer

Ac shuts down after long drive then ok again


The expansion valve is not working correctly on the a/c system. It is restricting the flow of freon from the a/c compressor to the condensor. So over a peroid of time driving the line will slowly freeze up and stop the flow of freon and the a/c will stop working completely. Will need to take it to a service center to have the freon gas removed and replace the valve. hope this will help you!!!

May 11, 2010 | 2005 Dodge Durango

1 Answer

Need to locate EGR valve on dodge durango 2005


EGR VALVE LOCATED ON THE INTAKE.IT HAS A SMALL ROUND LOOKINGIT HAS A METAL FLEXIBLE PIPE THAT CONNECTS TO THE EXHAUST MANIFOLD.

Feb 01, 2010 | 2005 Dodge Durango

2 Answers

2005 DURANGO GUSHING GAS TANK


There was a recall on this type of problem a while back. I had the same issue and brought it to Dodge to get fixed. You should have received something in the mail but if you didn't here is the information.
Make: DODGE Model: DURANGO Model Year: 2005 Manufacturer: DAIMLERCHRYSLER CORPORATION Mfr's Report Date: FEB 01, 2005 NHTSA CAMPAIGN ID Number: 05V034000 N/A NHTSA Action Number: N/A Component: FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP Potential Number of Units Affected: 26000 Summary:
spacer.gif ON CERTAIN SPORT UTILITY VEHICLES, THE FUEL TANK FILLER TUBE INLET CHECK VALVE MAY NOT FULLY CLOSE AT THE END OF REFUELING. THIS COULD ALLOW SOME FUEL TO ESCAPE FROM THE VEHICLE FILLER NECK. Consequence:
spacer.gif FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A FIRE. Remedy:
spacer.gif DEALERS WILL INSPECT THE INLET CHECK VALVES AND REPLACE THE FUEL TANK ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON APRIL 4, 2005. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403. Notes:
spacer.gif DAIMLERCHRYSLER RECALL NO. E01. CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.

Oct 11, 2008 | 2005 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

817 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...