SOURCE: Dashboard Lights will not go on Mazda Pickup B2500 1999
As long as all fuses are good, you need to check the light switch its self. Remove the light switch assembly from the dash. With a 12 volt circuit tester, check the wiring coming out of the switch. The dash lights will be powered along with the side marker lights.
Probe each wire that joins the switch, turning the switch on and off. If you don't have any loss of power here, it can be at the printed circuit board at the dash.
Bill
SOURCE: passenger side mirror, power, 2003 mazda Protege needs replaced
you need to remove plastic panel inside the door then you will find wireing plug undo and three bolts
to undo mirror ok m8
SOURCE: passenger side mirror
If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.
Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).
Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!
Get you new mirror and reverse the steps.
If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!
Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.
kb
SOURCE: Looking for the fuel pump shut-off switch for 1998 Mazda Pickup
The fuel pump shut-off switch is
located in the passenger’s foot well,
behind the kick panel. There is an access hole.
SOURCE: Replacing Ball Joints on 2001 Mazda B2500 (upper and lower)
its easier to get the whole control arm and the lower one has to be pressed in. it is not and easy job if you dont have the right tools checkout rockauto.com to look at the replacement parts and to get a price on them
655 views
Usually answered in minutes!
×