Question about 2001 Honda Passport

1 Answer

How to remove alternator from 2001 honda passport

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Honda Master
  • 2,984 Answers

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:
    • Negative battery cable
    • Heated Oxygen (HO2S) sensor connectors
    • Exhaust front pipe
    • Heat shield
    • Starter wiring connectors
    • Starter motor
To install:
  1. Install or connect the following:
    • Starter motor. Tighten the bolts to 30 ft. lbs. (40 Nm).
    • Starter wiring connectors
    • Heat shield
    • Exhaust front pipe
    • Heated Oxygen (HO2S) sensor connectors
    • Negative battery cable

how to remove alternator from 2001 honda passport - 3094538.gif
Starter mounting

Posted on May 28, 2010

  • Greg Bernett
    Greg Bernett May 28, 2010

    Hi, just wondering if there is more info that you need....just wondering about accepting my fix.

    Thank you.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 Honda Passport won't shift into 2nd or 3rd gear. check engine light on

Have vehicle scanned for codes at autozone or similar this will give you an idea what is wrong

Jul 15, 2016 | 2001 Honda Passport

1 Answer

I charge my battery on my 2001 Honda passport it

Could be the battery or alternator. To check the alternator. Start the vehicle, then remove the negative side of the battery post. If it dies, replace the alternator. Have the battery checked with a load tester.

Oct 19, 2014 | 2001 Honda Passport

1 Answer

Replace alternator belt on 1997 Honda Passport

how do you replace the belts on a 1997 honda passport

Apr 09, 2012 | 1998 Honda Passport

1 Answer

How to replace an alternator in honda passport 1994

Unplug the connector on the back of the alternator, remove the bolts holding alternator to the mounting bracket.
replace the alternator, start in the bolts, and set the belt on. now use a small pry bar, to hold pressure against the alternator to tighten the belt. while holding belt tight, tighten down the mounting bolts. rehook connector on rear of alternator. if you feel safer, unhook the battery + terminal before you start the replacement.

Oct 20, 2009 | 1994 Honda Passport

1 Answer

Cannot get tensioner to release the arm, even a smidge, so we can

If you have a breaker bar with a socket on the Tensioner pulley bolt, you should be able to rotate the tensioner downward to release the belt. If it does not move downward, your tensioner may be seized up and need replacement. The tensioner is behind and to the left of the tensioner pulley, just above the alternator.

Apr 26, 2009 | 2001 Honda Passport

1 Answer

Can't figure out how to remove the belt tensioner on my 1997 Chevrolet Cavalier so I can change the alternator . . . HELP

you should not remove it, it should move if you put a 9/16 wrench on it and try both ways ...careful it has lots of tension

Mar 11, 2009 | 2001 Honda Passport

1 Answer

How does one remove the belt tensioner off a 2001 honda passport?

14 or 15mm socket to release tension. Use socket with leverage bar push/pull towards driver side. Will notice tension releasing, pull belt. Use 5/16 allen wrench for bolt in center, 12 mm socket for mounting bolt. Remove bolts, remove tensioner.

Feb 13, 2009 | 2001 Honda Passport

1 Answer

Serpentine belt


This is a picture i drew in paint , for the 2001 honda passport belt wrap with a 3.2Liter V6, picture worth a thousand words.

Dec 27, 2008 | 2001 Honda Passport

Not finding what you are looking for?
2001 Honda Passport Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides