Question about 1998 Suzuki Sidekick

1 Answer

Electrical remove the altenator

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,513 Answers

Hi,

Thanks for writing to Fixya.com.

Please find the steps for replacing alternators.

http://www.partsource.ca/doityourself/How-To-Remove-and-Install-Alternators-and-Starters.asp

Thanks for contacting Fixya and please accept the solution if it has helped you.

Posted on Jun 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace alternator 2008 aveo


disconnect negative battery cable. Then remove rubber boot on altenator. Remove nut and cable attached. Unplug and remove wire harness also attached to altenator.
Loosen and remove both bolts holding on altenator.
Remove altenator.
Reverse process to reinstall. Pry on belt tensioner with pry bar and socket to loosen belt and place on altenator pulley after it is installed.
Last reattach battery cable and start vehicle.

Jun 04, 2012 | 2008 Chevrolet Aveo

1 Answer

How to remove altenator from a 96 monte carlo 3.4 litre over head cam engine


  1. unhook battery
  2. take belt off - has a tensioner pull up on to release belt
  3. unhook wires from altenator-mark the wires so remember where they go
  4. take out bolt's that hold altenator on
  5. remove altenator -replace in reverse order

Nov 11, 2010 | Chevrolet Monte Carlo Cars & Trucks

2 Answers

Battery died (or not). When I give it a jump, the car starts, but as soon I remove the jump cable, car turns off.. What could be the issue>


Your issue is indicating two problems. First let's talk about how your charge system works so that you can see what happened. The battery is there to start the engine. At the point the engine starts, the alternator takes over and provides power to the engine and also charges the battery for the next time you start your car. If the alternator fails to work, the engine runs solely off the battery. The car should have indicated that the charge system is not working, maybe you saw a battery light on your dashboard. After some time, the battery is depleted and will not start the car or be able to run the engine. So it appears that you have a defective alternator, and also your battery is either discharged, or is also bad. When you hook up your car to jumper cables, you are running off of your buddy's charge system/battery, so when you disconnect them, your car dies.

Oct 19, 2010 | 2000 Mazda MPV

1 Answer

Install a altenator for a 2006 jeep commander


I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

May 20, 2010 | 2006 Jeep Commander

1 Answer

96 f150 altenator rmovel instal


Section 14-02A: Generator, Integral Rear Mounted Regulator, Internal Fan Type, 95 Ampere and 130 Ampere 1996 Bronco/F-Series Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 05/18/2000 Generator, 5.0L, 5.8L, 7.3L Engines Removal
  1. Disconnect battery ground cable (14301).
  1. Disconnect electrical connectors from generator (GEN) (10346).
  1. Remove drive belt (8620).
  1. Remove generator retaining bolts (3).
  1. Remove generator.


    Generator


    j6040a.gif


    Item Part Number Description 1 — Fuel Filter Assembly
    (Part of 9K601) 2 19703 A/C Compressor 3 8146 Fan Shroud 4 10A313 Generator Bracket 5 10346 Generator 6 389706-S2 Generator Retaining Bolts (3) 7 — Heater Hose Clip 8 — Heater Hose A — Tighten to 21-29 Nm
    (16-21 Lb-Ft)
Installation
  1. Install generator.
  1. Install generator retaining bolts (3). Tighten bolts to 21-29 Nm (16-21 lb-ft).
  1. Install drive belt.
  1. Connect electrical connectors to generator.
  1. NOTE: When the battery (10655) has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) (12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

    Connect battery ground cable.
2010&c18=modelyear&c35=wsm%2cgenerator%2c%205.0l%2c%205.8l%2c%207.3l%20engines%2cstj%2c14-02a%2cremoval%20and%20installation&s=1600x900&c=32&j=1.3&v=y&k=y&bw=1171&bh=491&ct=lan&hp=n&[aqe]

Apr 03, 2010 | 1996 Ford F150 Regular Cab

2 Answers

Replace altenator 2002 bmw 325ci


disconnect the negative battery. remove the belt by rotate the tensioner roller clockwise. from the left car side u will see three hexagon screw 13mm under the altenator. loose out the screw and remove the altenator. before that unplug the two wire behind the altenator.tq

Feb 28, 2010 | 2001 BMW 325

2 Answers

How to remove the altenator in a 1997 Deville


disconnect the positive lead to the battery and disconnect the wires behind the alternator loosen all 3 bolts / nuts and brackets and remove replace in reverse method

Sep 23, 2009 | 1997 Cadillac DeVille

1 Answer

Possible electrical issue i Toyota Camry 95


check the voltage regulator or any relay that connects the alternator, including the fuse.

Jul 17, 2009 | 1995 Toyota Camry

1 Answer

Electrical problem, drains battery, altenator is fine.


the best way to solve this to to pull fueses because there is something running after that is drawing power from the battery...

Jul 06, 2009 | 2007 BMW 525xi Sedan

2 Answers

Electrical problem


there was a short in the wiring harness which was grounding out the altenator so i put in a new wiring harness and it works just fine now

Jun 21, 2008 | 1996 Ford Windstar

Not finding what you are looking for?
1998 Suzuki Sidekick Logo

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...