Question about 2004 Ford F150

1 Answer

Where is located the map sensor on a f-150 2004 4.6

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 69 Answers

MAP sensor is usually a square looking thing with a vacuum line and electrical connector attached to it. If you somehow meant the MAF sensor then it is located in the air intake hose near the throttle body. Hope this helps.

MAP sensor is usually mounted to the fire wall of the vehicle.

Posted on May 28, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: need to know where the

4.6L, 5.4L & 6.8L Engines

  1. Disconnect the negative battery cable.
  2. Remove the accelerator control splash shield.
  3. Remove the Idle Air Control (IAC) valve electrical connector.
  4. Disconnect the throttle bypass hose.
  5. Remove the mounting bolts and the IAC valve.
  6. Installation is the reverse order of removal. Tighten mounting bolts in two steps:
    • Step 1: to 89 inch lbs. (10 Nm)
    • Step 2: an additional 90°
c17hydro_10.jpg
Idle Air Control Valve

Posted on Jan 23, 2011

airjer995
  • 5332 Answers

SOURCE: Where is the map sensor

drivers side towards the rear of the intake plenum
2060c84.jpg

Posted on Oct 17, 2010

SOURCE: kia MAP sensor

Same thing for me and my 07. Where is MAP sensor located?

Posted on Jul 04, 2008

Molson02536
  • 3854 Answers

SOURCE: Map sensor location

If you are looking at the motor from the front of the car it is on the right side of the plenum it has a wire hook up and it gets vacuum straight from the plenum its just a square box don't look like its important . Hope this makes some sense. 

Posted on Jul 01, 2009

  • 75 Answers

SOURCE: where is the map sensor located on a 2004 rodeo

check the right side of the intake manifold or the right rear of the intake manifold...

Posted on Feb 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

P1296 code 1996 Concorde


P1296 CHRYSLER - 5 Volt Reference Voltage Missing At Throttle Position Sensor
https://www.autocodes.com/p1296_chrysler.html

Mar 02, 2017 | 1996 Chrysler Concorde

1 Answer

Where is map sensor located on my ford mondeo mk111 di estste year 2001


most MAP sensors, are located right after the air filter it's probably a silver box with an electrical sensor to it

Nov 15, 2014 | Ford Mondeo Cars & Trucks

1 Answer

Map sensor location


The MAP sensor in your car is a Manifold Absolute Pressure sensor, and it is located inside of the manifold.

May 08, 2013 | 1987 Pontiac Grand Am

2 Answers

Where is the map sensor located on the pacifica


The MAP sensor on the Chrysler Conquest is located either on the passenger side or the driver side down around knee level. The Manifold Absolute Pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine's electronic control system.-------------------------------------------------------------------------------------
Car Key Programmers

Nov 27, 2012 | 2004 Chrysler Pacifica

1 Answer

Where is the map sensor located on a 1.9 litre vw jetta?


For exact location and replacing procedure of VW jetta MAP sensor,click the link below and follow the details with diagrams:-----Where is MAP Sensor Located on VW Jetta http://technoanswers.blogspot.com/2012/11/where-is-map-sensor-located-on-vw-jetta.html
---------These will help.Thanks.

Nov 25, 2012 | Cars & Trucks

1 Answer

Map sensor location


Located on top cylinder on transmission side.The MAP sensor is located either directly on the intake manifold or it is mounted high in the engine compartment and connected to the intake manifold

Check out related help links to MAP sensor and its problems:----
Click the link below:-----

MAF, IAT, MAP and Coolant Level Sensor problem all together on Mazda MPV? http://schematicsdiagram.blogspot.com/2011/12/maf-iat-map-and-coolant-level-sensor.html
----------

Oldsmobile Manifold Absolute Pressure (MAP) Sensor...

---------

How to test MAP sensor?

---------------
Working of Manifold Absolute Pressure (MAP) Sensor...
--------------These will help.Thanks.

Nov 23, 2012 | Cars & Trucks

1 Answer

I need to replace the map sensor in a 2.4 alero but I do nor know where it located.


Here is a diagram of where the map sensor is located on this particular vehicle, i have also included the removal and installation procedures as well

Hope this helps....

REMOVAL PROCEDURE

  1. Remove the air cleaner outlet resonator.
  2. Disconnect the manifold absolute pressure (MAP) sensor.
  3. Remove the MAP sensor attaching screws (1).
  4. Remove the MAP sensor vacuum hose (2).
INSTALLATION PROCEDURE

  1. Connect the vacuum hose (2).
NOTE: Refer to Fastener Notice in Service Precautions.

  1. Install the MAP sensor attaching screw (1).
Tighten
Tighten the screw to 6.5 N.m (5.7 lb in) .

  1. Connect the MAP sensor connector.
  2. Reinstall the air cleaner outlet resonator.


asetech74_0.gifasetech74_1.gif

Sep 15, 2011 | 2000 Oldsmobile Alero

1 Answer

Need piture for 1995 buick rivera supercharger of were the map sensor is at


MAP SENSOR ON TOP OF INTAKE BESIDE THE SUPERCHARGER. TAKE THE NEW MAP SENSOR USE IT FOR REFERENCE LOCATING OLD MAP SENSOR. WHEN YOU SEE IT ON INTAKE IF MATCH UP WITH OLD MAP SENSOR THEY MATCH UP YOU LOCATED THAT IT.

Sep 14, 2010 | 1995 Buick Riviera

2 Answers

Replacing the MAP sensor??


REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Locate the MAP sensor and remove the retaining screws
  3. Detach the electrical connector.
99e56ea.jpg

Fig. On the 3.1L engine, the MAP sensor is located alongside the intake manifold

06cd371.jpg

Fig. MAP sensor and its bracket arrangement-3.4L (VIN E) engine

c92a20a.jpg

Fig. Location of the MAP sensor on the throttle body adapter-3.4L (VIN X) Engine

ef21261.jpg

Fig. The MAP sensor is located just behind the throttle body mounting base-3.5L (VIN H) engine

c7cd8f9.jpg

Fig. MAP sensor and its location alongside the supercharger-3.8L (VIN 1) Engine

98ee1cd.jpg

Fig. On the 3.8L (VIN K) engine, the MAP sensor is located on top of the PCV valve cover
  1. Remove the vacuum hose and lift the MAP sensor from the engine.
  2. Installation is reverse of the removal procedure.

Hope helps (remember rated and comment this).

Aug 06, 2010 | 2000 Oldsmobile Intrigue

2 Answers

1998 chevy suburban map sensor


Hi, The Map sensor on a Suburban is located.
Beside of the ignition coil. on the intake.
Is a litle sensor with a connector of 3 wires.

I hope this work for you. OK

Jun 28, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
2004 Ford F150 Logo

657 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...