Question about 1992 Chevrolet Corvette

1 Answer

Having problem with my 92 vette dieing on me in

Having problem with my 92 vette dieing on me in the middle of the road!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chevrolet Master
  • 1,619 Answers

When was the last tune up? What was changed? Coils are notorious for a non running condition. Dead cell in battery or loose battery connections can make it stall. Bad alternator also. Bad fuel filter or fuel pump. Any of these are places to start checking.

Posted on May 27, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 92' Buick Skylark keep dying Out.?


You have 2 issues here #1 the engine is running hot . Test the cooling system fans they seem to be not working. #2 car dies i would start with testing the secondary ignition (spark).

Apr 30, 2014 | 1992 Buick Skylark

2 Answers

Died while driving and wont start


CK your distributor rotor ....pull it off and look in side the hole where it fit on the distributor shaft if it really black in side replace it . If OK then either your ignition module ( inside the distributor a little black block with wires going to both end of it ) or the Stator inside the distributor has shorted out . The stator is kinda hard to change if you don't have the right tools . i think rebuilt distributors from the parts store have gotten a lot cheaper then they use to be ; you may want to change the whole thing a new one will come with a new module and stator

Aug 05, 2012 | 1992 GMC Yukon

1 Answer

92 vette horn relay location and does it have any fuses?


it is behind the dash center warning light display panel above the radio

Oct 28, 2010 | Chevrolet Corvette Cars & Trucks

1 Answer

1991 vette. Driving down the road and the engine just quit. Changed the fuel filter. Now if it starts, it idles low and if you try to press on the gas pedal, the engine dies. Engine won't rev up.


Have the TPS (Throttle Position Switch) checked with a milli-volt meter, it seems like it is not working properly or is dead. if it is not working it won't send a signal to the ECM (Computer) to let it know how much the accelerator pedal is being depressed so it cannot know how much give fuel and air to give the engine. Also have the MAF (Mass Air Flow) sensor checked.

Jun 15, 2010 | 1991 Chevrolet Corvette

1 Answer

Power windows wont work on 92 vette. where is fuse for them?


Either behind the driver side kick panel or under the hood in a fuse box by the battery.

May 04, 2010 | 1992 Chevrolet Corvette

1 Answer

92 honda accord lx dies when put on brakes at a stop


Sounds like your timing belt is one tooth off on the cam, this I have seen before especially if it is a twin overhead cam. One tooth off will make it idle really low when stopping at the light especially if the engine is warm.

May 11, 2009 | 1992 Honda Accord

1 Answer

Dying


Sounds like you are losing vacuum pressure. I would have a mechanic check all your vacuum lines. I had the same problem a while back and all it was was a broken 92cent hose.

Jul 14, 2008 | 1992 Ford Explorer

1 Answer

92 CHEVY BLAZER DIED AND WONT START


ck modul inside distributor. it bolts inside with 2 1/4" head screws.

Jun 26, 2008 | 1992 Chevrolet S-10 Blazer

Not finding what you are looking for?
1992 Chevrolet Corvette Logo

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...