Question about 2001 Pontiac Aztek

1 Answer

I can hear window motor running. But window will not go up or down. Front drivers side.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 973 Answers

Posted on May 27, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

djxtreme979
  • 151 Answers

SOURCE: rear driver side window will not go up.

The window has slipped of the track.Try moving it up and down, back and forth. Gently. Try it.

Posted on Dec 29, 2008

chuck943
  • 783 Answers

SOURCE: how to remove inside door panal to replace window motor?

Remove the window switch bezel. It has a snap clip in the front just pry the front up with a pick or small screw driver the pull it forward and disconnect. Remove the plastic covers from the ends of the pull strap and remove the 2 screws.Then locate the 2 screws at the bottom of the door panel and remove.Then pull out on bottom of door panel and work your way up to release the plastic push pins.

Posted on Jan 29, 2009

  • 615 Answers

SOURCE: 2001 olds aurora 4dr electric windows down wont go up

If you handy, you most likely can repair this yourself. I have had this happen on two of my Auroras. The window regulators have a nylon part that retains the cable assembly. This part gets brittle as the car ages (really under designed) and the cable end pulls through it.

I have been able to modify the retainer by removing the nylon cover and slicing a little notch to hold the end of the cable. Need a picture here to really show how it's done. In any case, a couple of hour labor and it's fixed for free.

Posted on Feb 02, 2009

captainjeffq
  • 52 Answers

SOURCE: 1997 Nissan Altima Rear Driver side power Window.

Switch needs to be replaced. Its a common problem and isnt that difficult to replace. Once you get the door panel off, its pretty much unplug the old one and plug those wires into the new one

Posted on Apr 13, 2009

csmock132
  • 4669 Answers

SOURCE: driver side window 1/2 way down, can hear the motor in the door when i push the button but no movement.

Replace the regulator assembly

Posted on May 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 cadilac deville driver window off track. motor seems to work but window will not go up.


Window regulator is bad in the drivers door . Do you know what a regulator is ? The Trainer 24 Power Window Troubleshooting Do you know anything about automotive electrical testing ? How to read an use a wiring diagram ? Do you know there are two side to a electrical circuit ? B+ voltage an a ground side . Plus there is electronic control modules and class 2 serial data network involved . When you push the switch for a window othen then drivers window on the drivers door . a class 2 message is sent to the other doors modules . The correct module will then open it's window .
http://www.bbbind.com/free_tsb.html Check out free wiring diagram here .Enter vehicle info . year , make , model and engine size. Under system click on body & accessories , subsystem click power windows . Click search button , then click each link one at a time .

Mar 27, 2017 | 2003 Cadillac Deville

1 Answer

Electric Window not working. Need to know how to remove front door panels. Passenger door window completely down, but can hear lift motor running.


Sounds like you have a problem with your window regulator. you need to unbolt the motor from the panel and take window off the regulator. I also have a 99 intrigue and my drivers side window did the same thing. The wire cords on the regulator where frayed and we replaced it. Found a new one of Autopartswarehouse.com for about $42 dollars with the motor.

Aug 22, 2010 | 1999 Oldsmobile Intrigue

1 Answer

I have a 2002 Honda Accord EX 4-dr sedan. The front driver's side power window motor works (you can hear it), and the window will go down, but not back up. You can hear the motor when pushing the button...


Hi, the reason you hear the motor running but the window wont go back up is because the window regulator is bad. you will need to go to a parts store and get a replacement. you can get a replacement at Advance Auto Parts for $72.99. the part number is 741-766.

May 18, 2010 | Cars & Trucks

1 Answer

My drivers side window is down and it won't roll back up


Assuming power windows
Do you hear the motor running? - If not bad fuse, motor, electrical connection
If you hear the motor - Can you move the window my hand? Could be a bad window regulator (a cable and pulley that raises/lower the window - when driven by the motor).

Feb 24, 2010 | 2002 Honda Accord

2 Answers

Driver side rear window will not go up or down


check your ground you may need to run a new one.......i had to run a new ground for the driver side front window on a buick last month

Jun 25, 2009 | 2003 Ford Expedition

1 Answer

Rear drivers side window inoperable.


if you don't hear the motor it's probably got a short or bad switch. If the motor runs and the window doesn't move you have a damaged gear.

May 09, 2009 | 1995 Jeep Grand Cherokee

1 Answer

How to remove inside door panal to replace window motor?


Remove the window switch bezel. It has a snap clip in the front just pry the front up with a pick or small screw driver the pull it forward and disconnect. Remove the plastic covers from the ends of the pull strap and remove the 2 screws.Then locate the 2 screws at the bottom of the door panel and remove.Then pull out on bottom of door panel and work your way up to release the plastic push pins.

Jan 27, 2009 | 2000 Lincoln Town Car

1 Answer

1994 geo prizm windows in back go down but not up.


is this on BOTH windows?? it is odd they both failed at the same time.
If you here the motor running there is something inside the door has let go or falling off. the door will have to be taken apart to be fixed.
this is what's inside YOUR door. (passanger side, drivers side is just a mirror image)
44e5675.jpg 1. there could be a problem between the motor gear and the moon gear. or 2 (most likely) the regulator arm has come off the window track or the window track has come off the glass.
hope this helps.

Jan 22, 2009 | 1994 Geo Prizm

1 Answer

My front driver side power window is not working. One Minute it wont roll down but I can hear the motor. Then the next minute it was working fine. now the window is lose and i can move it up & down by...


you have to replace the window regulator reason why is because the cable ripped which would cause the motor to work without moving the window up or down .. regulator is the cable and the rails were the motor makes the woindow move up and down on. you have to replace it.

Aug 14, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
2001 Pontiac Aztek Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...