Question about 2000 Chrysler Concorde
Check the wiring going to light,wiring running along trunk hinge sometimes breaks, also check all fuses,the third brake light most times is on another fuse circuit,
Posted on May 27, 2010
It could be the Third Brake Light assembly is bad, remove the assembly and have someone step on the brake and you can check to see if you are getting current to the contacts or wires.
If no power, replace the assembly.
Posted on May 27, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: How do I replace the
High-Mount Brake Light
NOTE: Depending upon the vehicle, the center high-mount brake light may be accessed from outside the vehicle, through the trunk, or through the passenger compartment.
Please don't forget to rate!!!!
Posted on May 07, 2009
SOURCE: 1999 brake light do not work
the problem is the lamp failure indicator module locaten on the left kick pannel right against the fuse box i had the same problem with mine
Posted on Jan 06, 2009
The lense should unscrew from the outside , some bulbs are push and turn and some are wedge base which just pull out.
push and turn bulbs have a metal base but the wedge base are all glass.
I changed a high stop bulb on a 2001 odyssey in this manner.
Posted on Jun 26, 2009
this is not a bulb u must replace the entire LED fixture, to do this remove the inside trim at rear around rear hatch opening, then you will need to drop the headliner down to access the retainers that hold the third brake fixture in, very easy job.
Posted on Jul 09, 2009
Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.
Posted on Jan 28, 2010
Tips for a great answer:
Nov 30, 2011 | Dodge Cars & Trucks
Aug 23, 2011 | 1996 Mercury Mystique
May 02, 2011 | 2009 Nissan Altima
Oct 27, 2017 | 2005 Jeep Grand Cherokee
Jan 04, 2011 | 1998 Plymouth Neon
Nov 17, 2010 | 1997 Plymouth Voyager
May 18, 2010 | 2004 Buick Rendezvous
Jan 28, 2010 | 2003 Ford Windstar
Jul 26, 2009 | 1999 Pontiac Bonneville
May 07, 2009 | Oldsmobile 88 Cars & Trucks
247 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: