Question about 2002 Chevrolet Malibu

1 Answer

How do you remove a battery from a 2002 chevy malibu

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,374 Answers

First remove Hold down clamps . Next remove cables , negative first then positive. Then remove the battery,its a good idea to wear gloves and eye protection when doing this.

You must find out how many Cold Cranking amps (CCA) your car needs to start, thats the size battery you purchase. Make sure its top or side post and same physical size as possible as your old battery.
Installiation is the reverse of removal.

Posted on May 27, 2010


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1990 Answers

SOURCE: where is the flash located in a 2002 chevy malibu

It is on the Fuse panel under the Dash on the Drivers Side at the Top Right Corner of the Panel.

Posted on Jan 18, 2009

  • 1 Answer


Remove the starter and jump the connections to a Battery to see if it spins. Make sure you connect positive to the positve end and the neg to the neg end. Hope this helps.

Posted on Jul 02, 2009

  • 77 Answers

SOURCE: thermostat on a 2002 chevy malibu

Which engine>? There are a few different engines available.

Posted on Jul 28, 2009

  • 77 Answers

SOURCE: How do I remove the driver door panel on a 2002 Malibu?

The door panel is held on with small plastic fasteners. Go to your local auto parts store and look in the auto body section for a trim removal tool.

If you do not want to buy the tool, you can use a flat tool of some sort.
Without the tool, you will need to buy plastic fasteners to replace the ones you ruin. (you'll need a flat prying tool at least 8 inches long and 2 inches wide)

Insert your flat prying tool in between the door panel and the door frame. Carefully work your way around the door, slowly popping the panel loose. Once you have the biggest part loose, you will have to pull up on the top and remove the rubber stripping between the window and door frame. Avoid at all cost ripping the plastic fasteners out of the door panel. You want to pull them loose from the door frame. More than likely, you will ruin several of the plastic fasteners. As I mentioned before, you can buy these at the auto parts store. I suggest taking a few with you so you can match them up with the new ones.

Posted on May 14, 2010

  • 343 Answers

SOURCE: Chevy 2002 Malibu ERG valve

Symptoms of a bad EGR valve are usually stumbling idle or the engine stalling when the car is warm (normal operating temperature). Find the EGR valve and locate the vacuum line attached to it. Start the engine cold and wait for it to warm up. When the engine starts to stumble, pull off the vacuum line. If the EGR is bad, the engine idle will stabilize and no longer stumble.

Posted on May 25, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 malibu theft system

There is a box under neath the steering wheel that allow for the theft system of a 2002 Chevy Malibu to be disconnected. ------------------------------------------------------------------------------------------

Feb 18, 2013 | 2002 Chevrolet Malibu

2 Answers

Gas gauge doesn't work changed out the fuel pump or the fuel card and still don't work it's a 1999 chevy malibu

Just had a new fuel pump installed in 2002 Chevy Malibu. Worked great for about a week and then the fuel gauge started reading "empty" when the car has a full tank of gas. What happened?

Jun 13, 2010 | 1999 Chevrolet Malibu

1 Answer

How do I change the thermostat on my 2002 chevy malibu

The exhaust manifold between the tran and engine has a sheild over it. I would remove that sheild to gain access to the thermostat housing or remove the exhaust manifold to have an easier access to it

Apr 17, 2010 | 2002 Chevrolet Malibu

1 Answer

The positive terminal bolt is stripped and will

Remove the terminal and replace it with a new one. It's a very cheap part can be found almost everywhere.
Here is how it looks like

Apr 09, 2010 | 2002 Chevrolet Malibu

1 Answer

Alight is coming on in dashboard that looks like either my battery or my radiator and it looks like it is telling me it is low on fluid. what does this mean? I have a 2002 chevy malibu

first you have to determine which it is or you can check both for proper levels i doubt its your battery,Chevy installs maintenance free battery's, so let it cool off then check you coolant level,if any has been lost i would be concerned and look for leaks ,have it pressure tested.

Jan 27, 2010 | 2002 Chevrolet Malibu

1 Answer

How to replace the ignition solinoid in a 2002 Chevy Malibu? I know the problem but I can't seem to get the wiring detached from the switch.

Most people replace the starter/solenoid assy. because the solenoid is not sold separately. I believe this is you case. Below is a good option.

First disconnect the battery negative(GND) cable. Remove the two bolts which hold the starter to the block. Careful not to let it drop and hit you in the head, Unbolt the small signal wire to the solenoid and then the large red starter cable which goes to the battery +. Installation is reverse procedure.

2002 Chevrolet Malibu - Hi Test Starter Part Number: HITEST6491 Manufacturer Number: 6491 hi-test.gif starter.jpg Our Price: $106.80

Core: core-icon.gif The “core” is your old part. Send us your old part and the core deposit will be refunded to you upon receipt. Detailed instructions will come with your order. $64.00

Jul 05, 2009 | 2002 Chevrolet Malibu

1 Answer


Remove the starter and jump the connections to a Battery to see if it spins. Make sure you connect positive to the positve end and the neg to the neg end. Hope this helps.

Jul 02, 2009 | 2002 Chevrolet Malibu

1 Answer

Replace the water pump on a 2002 Malibu

What size motor If it is a v6 most of them you are easy drian the radiator down take the pulley of the pump and you will remove the bolt and pump

Apr 03, 2009 | 2002 Chevrolet Malibu

1 Answer

What type of replacement cables 2002 chevy malibu has new battery

yup...however, most likely the connections or the terminals.

Mar 21, 2009 | 2002 Chevrolet Malibu

2 Answers

Cannot locate horn for a 2002 Chevy Malibu

the horn is behind the passenger front fender. right in front of the tire. you need to remove the dust cover to gain access to the horn(s).
the picture was shot from underneath the car. you can not get to the horn(s) any other way.


Mar 20, 2009 | 2002 Chevrolet Malibu

Not finding what you are looking for?
2002 Chevrolet Malibu Logo

1,161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides