Question about 1994 Honda Accord

1 Answer

Skipping when gets hot

Put new dist on

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 6,826 Answers

Check the egr valve solenoid.

Posted on May 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 geo prizm 1.6L starts fine when engine cool but when warm it cranks fine but won't fire. I changed plugs, wires, dist cap & rotor & it started fine til got warm again. What might be my issue?


toy 4afe engine.
warm no starts.
so did you check for spark loss , warm? or hot?
if not why not?
if spark is good, did you use test fuel to see if added fuel starts it?
are the the spark plug tips (yes,look) soaking in gas (failed) or dry.?
this is how you diagnois all Gas engines. even a lawn mower.

ever do the 60k lash check on valves?
put in a new timng belt, may be yours slipped, its a 60k service.
do the lash checks at 60K,
if lash is too tight, the gap can go to zero hot,killing compression
Valve clearance (engine cold), (in.):
Intake (0.006) 6 thou
Exhaust (0.014) 14 thou.
why not do the FULL 60k tuneup now. not cutting corners or skips
and win.

is the CEL out , hot driving>
the check engine light.??

Apr 19, 2014 | Geo Prizm Cars & Trucks

1 Answer

I have a 89 nissan pathfinder.3.0L 4+4. will run.some times.it just skips.cut it off.start it back up.then it runs good.some times hard to start.then starts skipping.new distriberter.fuel pump.all the


The problem of your car is that the fuel system/electrical system is malfunctioning. You mmust make the mechanic draing the gas from the tank, clean the tank, change the fuel filter, service the fuel injection system if it has it and if it is caburetor system service the carburretor, change the spark plugs and the air filter element.

Jan 18, 2013 | Nissan Cars & Trucks

1 Answer

Catalytic converters get red hot


If you have a skip,,then thats what killing the cats..If the new one turn red on ya,,you probably already melted the inside..Need to fix the skip before you go any further..They wont warranty the cat if it melted on the inside

May 08, 2012 | 2001 Ford Taurus

1 Answer

Crv shut down oil cap lefted off and oil all over engine and truck shutn down checked and found oil fill the spark channel and boots so replace the gasket and plugs and cleaned off the wires and now have...


have you put a new set of plug wires on it. use a spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and see if shaft of dist, is turning. some of the hondas have a plastic type drive gear on bottom of dist, shaft. that goes bad.

Sep 21, 2011 | 2000 Honda CR-V

1 Answer

Replaced the distributor and cap the dist was


can you please describe the engine a bit better is it a 1985 model with carb and points or a later model with fuel injection and ignition module .

May 29, 2010 | 1985 Ford Thunderbird

1 Answer

1991 DeVille: 1991 cadillac deville skipping what is causing it...


bad plug or wire, dist cap, rotor button,vacumn leak or rocker arm off

May 17, 2010 | 1991 Cadillac DeVille

1 Answer

Truck skips


timing chain may be bad put the cylinder on #1 up to the top and make sure the timing marks on the front pully is pointing to the fromt timing mark o degrees next pull #1 plug pull distributor cap and move the fan back and forth watch the rotor if it takes time to move then you have a badtiming chain. if not try replacing the oil pressure switch behind and below the distributior.

May 24, 2009 | 1990 Chevrolet C1500

1 Answer

1990 honda civic dx


maybe fuel fouled plugs seen it happen many times check timming belt ohhh check rotor under dist cap they melt and turn if thats it u need a new dist bearings going out and get hot

Sep 18, 2008 | 1990 Honda Civic

2 Answers

85 dodge ram wont start


You may want to recheck your plug wires.You could have put them in the wrong places.

Aug 25, 2008 | 1985 Dodge Ram 3500

Not finding what you are looking for?
1994 Honda Accord Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...