Question about Lexus ES 330

1 Answer

I OPENED THE HOOD TO JUMP START IT, NOW THE STICK THING THAT HOLDS UP THE HOOD WON'T GO DOWN TO LET ME CLOSE THE HOOD.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

HI SEE TO PUSH IT UP AND DOWN

Posted on May 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hood won t close


Check out the cable connection between the latch and your internal latch control. Till you locate the problem I would suggest tying down the hood with some sort of strap so it does not pop open at speed.

Apr 24, 2017 | Chevrolet Malibu Cars & Trucks

1 Answer

Remove a hood from a 2006 nissan altima


absolutely not. first thing, carefully remove the washer hoses. there are four bolts on the hinges. just remove front two completely then slowly remove rear two while someone else holds the other side of hood. the hood itself is relatively light.when reinstalling, keep the hood bolts slightly loose and bring down the hood slowly, not letting it close. when you can position the hood straight, tighten a bolt on either side then close the hood. if it closes and opens while being evenly gapped on both sides tighten all four bolts. then replace the washer hose and done.

Nov 13, 2013 | Nissan Altima Cars & Trucks

1 Answer

I over heated,the serpentine belt snapped. Opened the hood to find steam rapidly coming out of both the antifreeze and out of the engine right by the head gasket. It wasn't smoke not blue or black jus


Perform a compression test on your cylinders. One unfortunate result of overheating is the blown head gasket. Without compression your motor will not run. Tester are not super expensive or some stores will lend tools.

Jul 09, 2013 | Cars & Trucks

1 Answer

How do u jump start BMW without being able to get to battery


Hi Ricky

Under the bonnet/Hood you should see a red cap thing with a + sign on it, this is the possessive to the battery lift off the cap and there should be what looks like a brass looking bolt connect red live jump lead to this, and the earth wire can connect to any ware under the bonnet/hood where it will make a ground, some also have a black thing with a - on it just connect the earth/black jumper to that and then you can jump start hope that helps

Apr 03, 2013 | 1998 BMW 740i L

1 Answer

Where is the latch for opening the hood ?


The red release latch is down under the dash on the extreme left hand side. A release tongue should stick out from the radiator grill when the latch is opened. Pulling on this tongue will release the hood When you open the hood the angle is initially restricted to about 45 degrees which is fine for minor jobs. If you need extra room, the left hand hinge has a latch pin which can be swung inwards to allow the hood to move up to about 50 degrees. Releasing the second latch pin on the right hand hinge allows the hood to go vertical. You will have to release the left hand hinge latch pin to close the hood.

Jul 12, 2010 | 1988 Mercedes-Benz 300

1 Answer

Opened hood now it won`t close


this is common it needs to be lubed, you will have to spray it good with wd40, then locate the release arm that the cable pulls to release the hood,push the arm back, have someone inside to pull the hood release lever,do this a few times and respray it until its free, here a picture of the latch, i put an arrow pointing at the lever to push back and free. hope this helps you.0429669.jpg

Mar 01, 2010 | 1999 Ford Expedition

1 Answer

My car wont starti tried charging my battery, got my starter checked tried to jump start, changed my battery posts and nothing. what can it be? the strange thing is that one day every thing was fine and...


Hi

you said you did the jump start? but nothing? maybe the relay is the problem, did you you see a relay inside the small fuse box? or maybe the carbon brush is empty and need to replace..

Thanks!

Jul 08, 2009 | 2001 Kia Sephia

1 Answer

Clicking noise under hood of 2001 Chrysler Sebring


Sounds like you have a dead battery. You either need a jump start with jumper box or clean battery terminals and see if that works

Dec 02, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

917 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...