Question about 1998 Honda Accord
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
these cars have i issue of the knobs breaking in the back try switching the blower knob with it and see if it works as far as the clock they are not tied together most likely the bulb is burned out stick a small screw driver under it pull down the clock pops out you will be able to see the bulb
Posted on Oct 29, 2008
Your car probably has two fans at the radiator, one is for the coolant and the other is for the a/c condenser. Find out which one stays on after you turn off your car after a normal trip, this fan is good. Check the fan that did not run, you may have to connect 12v directly to the connector of the non working fan, if it won't run with a direct connection, the fan motor is bad, if the fan does run, then find the fan switch and test or replace it, you can find information on testing a the Autozone.com site.
Posted on Aug 10, 2009
Sorry for the delayed response. For future reference, the blower motor resistor in an 04' Honda Accord is located under the glove box and a little to the left if you are facing it (the glove box). You just need to pull out the plastic panel (yes, you can just pull it out by hand, no tools needed for that). It should be right on the fire wall with a plug going into it. If you reach in there and pull the plug (it has a little notch so it clips into the resistor more securely; make sure you push the clip in) it should have 4 flat prongs on it that go into the resistor. The resistor itself will have 2 phillips head screws that are holding it into the fire wall. Unscrew them and you have the resistor. If you can unscrew both screws before unplugging, it will be easier to see how it unplugs. I know this sounds complicated but once you get in there you will notice it's fairly easy to change out.
Posted on Apr 23, 2010
If you are absolutely confident the AC compressor is not kicking out on low pressure then it is the blend door actuator.
The blend door determines how much air blows through the heater core or evaporator.
The actuator can be purchased at dealer and maybe at a local part store.
Posted on May 27, 2010
Tips for a great answer:
May 25, 2012 | 1999 Chrysler 300M
Jul 17, 2010 | 2000 Honda Accord
Sep 01, 2009 | 1999 Jeep Grand Cherokee
Aug 14, 2009 | 1999 Honda Accord
May 15, 2009 | 2004 Honda Accord
Oct 18, 2008 | 1999 Honda Accord
Sep 07, 2008 | 1999 GMC Yukon
968 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: