Question about 1996 Buick Park Avenue

1 Answer

1996 buick park avenue. the car stalls mostly at a stop light what could it be. I ran a scan and it cam up it could be the crank sensor, control moduel, or cam sensor.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 79 Answers

I like to replace cam

Posted on May 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 park ave ultra is hesitatating when I start using the gas as I start an incline mostly but sometimes just randomly an it's getting worse


Engine Stalling Due to Mass Air Flow/Crankshift Position ...

repairpal.com > Problems > Buick > Park Avenue
Buick Park Avenue Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor Failure. This is a verified ... 1997 Buick Park Avenue- 3.8L V6160,000Visitor. Engine stalls ... car runs then stalls and won't start for thirty minutes. Upvote (36).

Buick stuttering Questions & Answers - Fixya

www.fixya.com > Forum > Tags > stuttering
94 Buick Park Avenue that stutters under a light load I have a 94 Buick Park Avenuethat ... Buick Century 97 runs rough and stutters when cold and gas applie Engine runs rough ... I have a 1994 buick lesabre it starts ok but stutters and stalls.

Oct 30, 2015 | Cars & Trucks

1 Answer

Where can i find the cam shaft position sensor on a 1996 buick park avenue


This is a very difficult repair. I would guess you're already into it hip deep. The specs for this engine is available in the Chilton's manual. Every library reference section has one. Look under "cam shaft-remove and replace.

Dec 07, 2014 | 1996 Buick Park Avenue

1 Answer

I have a 2007 jeep patriot. It stalled at stop sign started ran rough. Parked came back drove it home ran u- scan code p0017 replaced crank and cam sensors still runs rough changed plugs were bad. I was...


code p0017 refers to crank/ cam oosition sensor bank 1 sensor B -correlation ===causes --wiring--CKP sensor--CMP sensor--mechanical fault.
It also refers to control modules, cooling fan--no signal===causes -- wiring--ECM.
If it has a timing chain then the the advice that it will not be the chain is good. So I suggest checking out the cam/ crank sensors and wiring

Oct 22, 2013 | 2008 Jeep Patriot

2 Answers

97 buick park avenue change cam and crank sensor still no fire


asd relay or fuse
camshaft not spinning
bad pcm
damaged wiring harness

Mar 25, 2013 | 1997 Buick Park Avenue

1 Answer

Rough idle, loss of power, stalls


check plugs wires and coil pack if good check timing of cam to crank may need to replace crank senser or cam senser

Jan 19, 2013 | 1996 Buick Park Avenue

2 Answers

96 buick park avenue wont start but turns ova theres no gas gettin to the engine


you probaly have a bad crank sensor. this will not let the fuel pump kick in if it goes bad

Apr 20, 2012 | 1996 Buick Park Avenue

2 Answers

I have a 1991 buick par avenue with 3800 engine. The car periodcally stalls while it is running. It is easily shifted into neutral and restarted, but can be dangerous at high speeds. So far the garage has...


the price for the ac service sounds steep. The Stalling can be caused by ac but I have not came across this at high speed. Did they replace the Crank sensor?? Or the ICM? These can cause these issues. The crank sensor more so than the ICM. The cam sensor usually does not cause a stalling that I have ever dealt with. they will cause some issues but not at high speeds.

Oct 16, 2009 | 1992 Buick Park Avenue

1 Answer

Car can stall in warm weather


Most likely if it is temperature related you may have a temperature sensor that is failing. The sensor may not be reacting properly to the actual temperature and causing the engine to run rich in warmer weather when a richer setting is not required.
You could have a sticking injector or sticking EGR valve or a faulty TPS switch, all can cause a rich condition and a poor running engine.
Is the service engine light on or come on at some point?
I would start by having the car scanned for trouble codes. You can have the scanned at no cost to you at your local Auto Zone or Advance Auto Parts. Write the codes down and respond back.

Sep 19, 2009 | 1996 Buick Park Avenue

Not finding what you are looking for?
1996 Buick Park Avenue Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...