Question about 2001 Cadillac Catera

2 Answers

Engine check, abs, trc, gas cap, leveling, plus speedometer goes to 0 while driving. all started after car was washed. Does this often and then goes to normal all turns off, and turns on after while driving awhile. Told could be control module or speed sensors, ??? any clues to this? Also where is the control moudule locate on my Cad. Catera 2001?

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 113 Answers

Traction Control Module mounted on the ABS pump just behind the battery. There are places in the US that will rebuild them for you for about $100-150.

You should also have no power steering and no cruise....correct?

If you want to know how top remove and replace, email me at lorlaman@gmail.com

Posted on Jul 30, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 44 Answers

Check to see is if you have a bad grounding wire. Common cause for these kind of problems.

Posted on May 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Frm beginning of 2004 nissan maxima ABS problem to present want threw car wash ABS and Brake lites came on on the dash. checked rear sensors 1 worn so replaced sensor and hub assemble and did the recall...


can you do me a favor just unplug the abs module lead, and check that part first then get back to me on here. it is very rare that an abs sensor fails. its always down to the wiring plugs. and a car wash will throw the water in the engine bay, not like road water and any seal that are weak or cracked will be the first problem. plus engine dieing is a good sing the abs unit is not working at all. bad part is if the unit is not completely damaged. if the engine starts without the abs plugged in. but will not when its plugged in. can be a problem with the abs control unit board.

Feb 23, 2014 | Cars & Trucks

1 Answer

TRC, VSC and ABS warning lights go on on dash


dirty sensors in each wheel and dirty pick up in each wheel .

Dec 23, 2013 | 2006 Toyota Corolla Verso

1 Answer

ABS, TRC OFF, VSC and Hand Brake lights on


Clean all the sensors for you abs and wile you there see if the wheel bearings are good and drive shaft, some times they mess with the sensors.

Feb 28, 2013 | Cars & Trucks

1 Answer

Intermittent electrical fault Saab 9-5


Check connectors,pins grimping force,bad contact between pins in main plug connector(abs unit)or connectors near pilar A left.
Good luck!

Sep 29, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Warning lights


have obd  scanner run on vehicle 

Sep 12, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Saab '02 9-3 "electrical"problem


Most likely it is the ABS module is going bad and needs to be replaced or rebuilt at www.bba-reman.com, hope this helps.

Sep 02, 2009 | 2000 Saab 9-3 Viggen

1 Answer

BMW all of the gauges went out on my front console.


Check the temp sending unit, and then fuses.

Aug 12, 2009 | 2001 BMW 330

1 Answer

ABS and TRC lights come on


Hi,try disconecting the negative cable from your battery for a minute to resset the computer .....C1

Nov 27, 2008 | 1999 Mazda 626

1 Answer

Abs


There are speed sensors for the abs in the front wheel bearing assemblies. Rust builds up and changes the air gap between the speed sensor and the reluctor ring inside of the hub. The rust needs to be cleaned away to restore the proper air gap it fix the problem.

Sep 03, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
2001 Cadillac Catera Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...