Question about 2002 Chevrolet Tracker

Open Question

License plate bulb replacement tips chevy tracker 02

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
eitan
  • 291 Answers

SOURCE: changing license plate lamps on the tracker

There's no need to take the whole back panel off to do it, the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.

Good luck,
Eitan.

Posted on Jun 10, 2008

Ad
  • 1027 Answers

SOURCE: license plate light replacement

The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.

Posted on Apr 18, 2009

techbuster
  • 5081 Answers

SOURCE: 1999 Dodge Neon rear license Plate bulb

LICENSE PLATE LAMP BULB
REMOVAL

  1. Remove screws attaching license plate lamp to rear bumper
  2. Remove lamp from bumper.
  3. Remove bulb socket from lamp.
  4. Pull bulb from socket.

INSTALLATION
  1. Install bulb into socket.
  2. Install bulb socket into lamp.
  3. Place lamp in position.
  4. Install screws attaching license plate lamp to rear bumper.

Posted on Oct 08, 2009

techbuster
  • 5081 Answers

SOURCE: need to replace license plate bulb on my 2005

1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.

Posted on Nov 01, 2009

  • 196 Answers

SOURCE: 2000 Buick Lesabre custom liscense plate bulb

kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together

Posted on Mar 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Plate light does not work, but lights are good and sockets seem good


check bulb the number plate light runs on the same circuit as the side lights so if they are working its got to be a bad earth on the plate light

Jan 24, 2016 | Cars & Trucks

1 Answer

2007 chevy equinox license plate light won't work after bulb and fuse replacement


Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .

May 23, 2015 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

My 2005 chevy tahoe 5.3 license plate light went out i replaced bulbs problem still there what is the fuse labeled for that circuit?


Check the brake bulb socket for short , clean replace bulbs , check connector to rear licence plate lights . Also trailer harness for short , all on same fuse circuit .

Jan 23, 2013 | 2000 Chevrolet Blazer

1 Answer

How do you get the license plate bulbs out of a 2003 chevy zr2 tracker they have never been replaced and I just cannot get them out do you twist or pull please help thanking you in advance Deb


they are the type that pull out, they can break easily if you are not careful, you can get a new socket and bulb pretty cheap at the part store and they are easy to install.

Oct 04, 2012 | Cars & Trucks

1 Answer

How to change license plate bulb in chevy tracker ?


The light socket goes in from the back it's rubber and only truns a quarter of a turn and pull out. the bulb is a 194 and most all dept stores and auto parts stores will have them they are a very common bulb. a 168 will also fit.

Aug 22, 2011 | 1999 Chevrolet Tracker

1 Answer

Replace license plate bulb.


You need to pull the cover of the bulb off, There may be a clip it may need help from a screwdriver. Replace the bulb and replace the cover

Jul 05, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Where is the fuse for the license plate bulbs of a 2002 Chevy Tahoe


the headlamp switch controls the license light. the filament in all bulbs react as a fuse when shorted out. replace the bulb

Feb 20, 2010 | 2002 Chevrolet Tahoe

1 Answer

License plate bulb


right above the plate the bulb should be.

Nov 23, 2008 | 1997 Chevrolet Blazer

1 Answer

How to replace headlight on a 2003 Chevy Tracker


There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.


Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

Oct 02, 2008 | 2003 Chevrolet Tracker

1 Answer

Changing license plate lamps on the tracker


There's no need to take the whole back panel off to do it, the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.

Good luck,
Eitan.

Jun 08, 2008 | 2000 Chevrolet Tracker

Not finding what you are looking for?
2002 Chevrolet Tracker Logo

Related Topics:

894 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...