Question about 1993 Chevrolet Corvette

1 Answer

Need to know what te replacement battery is for a 1993 corvette key fob.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 973 Answers

Take out the old battery from your key fob and it should have the markings on the old battery.

Posted on May 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Programming my new fob for 2006 corvette,


This procedure will add or replace key fobs. To perform this procedure you must have the following: a fob already programmed to the module, a replacement key fob, and a scan tool
Dealer

Nov 01, 2017 | Cars & Trucks

1 Answer

Security system reset


You may need to check the owners manual for a Corvette. Most GM models can be set by leaving the key in the on position for a few minutes with the engine off, or by locking and unlocking the drivers door with the key.

Jun 08, 2013 | 1999 Chevrolet Corvette

1 Answer

Change battery in my 2006 Corvette fob


I would go to my G.M. dealer they can change the battery as well as reprogram the fob if needed

Sep 18, 2012 | Cars & Trucks

1 Answer

Key fob


The key fob just carefully snaps open. Refer to the owners manual

Jun 13, 2012 | 2008 Chevrolet Corvette

2 Answers

We need to chage the battery in our 2006 corvette key fob. How do you open it?


There should be a slot on one end that you can put a penny into or something similar, and it should pop open.

Jan 21, 2011 | 2006 Chevrolet Corvette

1 Answer

My 2005 corvettes battery was drained after sitting for too long. I recharged the battery but when I tried to restart the FOB were not being detected and the horns and lights go off like someone is trying...


The car's security/keyless entry system needs to be reset, and it's not recognizing the keyless entry FOB.

Check this LINK for how to re-program the FOB, which should allow you to turn off the alarm.

I don't know how to reset the alarm without the FOB, but it should be in the Owner's Manual.

GL,
Td

Aug 06, 2010 | 2005 Chevrolet Corvette

1 Answer

Car (Z-06) is not recognizing either of the two (2) Fobs. What can be the problem. Can they both need batteries? Unable to get in car with the Fob and unable to start the car with the Fob. What can the...


THis model has an immobilizer/transponder in the key that registers with the car. It is possible both batteries went dead if both have been used a lot or sat around, havent been changed since new, etc. If they havent been changed my suggestion is to try.. its a 10 dollar fix if thats all it is. Unless they both got damaged by water or other trauma to them. Otherwise its not the fobs that are broken but the receiver unit in the car that gets the signal from the fobs. All FOB's are FCC certified because they run on low power radio frequency to send a signal from them to the car. That same frequency is used to validate the fob being used to start car is the same as belongs to the car.. They MATE. At your local Autozone they ahve an energizer battery display that has a GENERIC reciever with a green light. Its set up to tell you if you need to replace the battery in your fob as the green light comes on with any received radio signal. This would be a way to test the FOBS and make sure they are broadcasting. You can get the batteries there too! If you determine they are working get ready to shell out some bucks.. I believe onstar is in your GM product and because of that the radio receiver for the keys and the onstar system are intertwined and have to be changed at same time...The one thing Im NOT certain of is if your corvette came when GM was offering 5 year warranties. If it did the FOBs wouldnt be covered but the receiver in teh car would be...

Jun 05, 2010 | 2006 Chevrolet Corvette

1 Answer

93 vette won't start


no if they did not get the pin right in the computer have them tow it back and redo the key fob and computer.

Jul 01, 2009 | 1993 Chevrolet Corvette

Not finding what you are looking for?
1993 Chevrolet Corvette Logo

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...