How do i reset the flat tire light on the dash after i changed the tire?

My Lesabre has buttons on the left side of the dash. The one called Gage Info has a number of things like oil pressure check tire pressure heat Battery. Push this button till it says check tire pressure To reset your light push the reset button and hold for fifteen or twenty second and the light on the dash should go out and it will show tire pressure ok on the gage. Before you reset check all four tires for air as one tire could be down 8 or 10 lbs and the light will come back on. they all have to be the same pressure.
When you change your oil you should reset the oil section as well and hold reset the same as above. The oil section tells you how much oil you use over an amount of time.

Don't forget the spare tire pressure.

Hello, some vehicles require to be manually reset. Some reset buttons are in the fuse box and some under dash.

How do I reset the tire sensor warning light on my dash for an 06 325i

iI you mean 'how to turn change oil light off" go to fuse panel. Open drivers door there is a panel cover on the side of dash board, remove cover there is a red RESET button that resets oil pressure and tire pressure. Turn the ignition key to the on position but don't start the car. Now press and release the reset button the change oil light should start to flash, now press and hold the reset button until you hear chimming hold until chimming stops then release, the change oil light should go off. If you need to reset tire pressure press reset button twice, the first push will make the change oil light flash the second press will make the tire pressure light flash then hold untill chimming stops, light should go out . Hope this helps.

Most will reset when the air pressure in all the tires is close to the same pressure.

There are 4 key ignition settings: Off, Acc, On, Start Turn key to the On position, quickly press the gas pedal 3 times, then turn key clockwise to Start position and actually start the car. You'll hear it chime at you and the change oil indicator light will flash and disappear.

The tire light....Have you checked all your tires for prper air pressure? including the spare? If they all have the maunfactures recomended PSI. Remove the negitive post from the battery for 20 min. to rest puter. If that dont work you have a faulty TPMS on a tire need a new one. Hope this helps

Your tire pressure monitor needs to be reset whenever you change or rotate your tires...

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Because of changing outside temps this happens, just hold reset button on left side of dash until it reads tire pressure 100% again, just make sure your pressure is right before you do it. this is the same for oil changes and the like.

tire reset, light on dash will come on if brakes notice a pressure change in tires/breaking or if any maintence to tires, breaks, change + or neg in air pressure. to reset push and hold button for @3 sec.