1988 Pickup: 1988 toyota pickup wiper arm removal????...

Remove the cap and remove the screw.Shake the arm and remove from the cone shaft. start the wipers and stop,let park and install the arm again on the right place. tight the nut and check if park without hitting the hood.If the arm feel lose you need to replace the bushing from the links driving the arms.
Good luck

Try this link to get you starter fixes:

1993 Toyota Pickup Truck Starter Motor Repair

This site is useful with diagrams:

88 Toyota pickup when trying to start the starter relay clicks

Should be plastic cap on arm at base then bolt underneath. Both arms

Did you remove the cap off the bottom of the wiper arm first?

How do you remove the alignment/belt holder off of a 1988 Toyota pickup?

Pop the plastic cap off the wiper arm and tighten the nut that holds the arm on .

lift the wiper arm up, at the arms head where it sits over the drive post look for a small tab, take a pocket screwdriver and move this tab outward, then wiggle the wiper head to remove, they can be really hard to get off.

a wiper transmission arm should do.

ther are two little hole in the drum that are threaded put two bolts that match those holes and thread them in untill the drums pop off

There is a cotter pin in the window crank, a pair of needle nosed pliers should be able to grab it