Question about 2004 Toyota Tundra
There is no reset, when the probem that caused the control module to turn the warning light on senses the problem is repaired then the light will go off, it runs a self test everytime the key is turned off and back on, u can have the system tested to see what fault code is present that is causing the light tostay on and warn you of a problem in the system. d
Posted on May 16, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.
Posted on Aug 04, 2009
SOURCE: Check engine and VSC lights on
that the check engine light is on indicates a problem. that the light is not flashing indicates that the computer does not think that the problem is all that bad. without some other vehicle malfunction symptoms best advice i can give you is to take your vehicle to a place that has a code reader and see what codes it has stored. some car parts stores will retrieve the codes for free, idea being that the parts store can then sell you some parts to fix the problem. but you don't have to buy anything, you can just have them read the codes. some of the parts stores will give you a printout of the codes too. get the codes and you know what the computer is not liking, then you can make a more informed decision about what to do next. hope that helps.
Posted on May 28, 2009
to reset for a momentany malfuntion,disconnect the negative battery terminal few minutes, reconnect,start engine and drive to check
Posted on May 03, 2009
It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.
Posted on Jul 23, 2009
Tips for a great answer:
Jun 02, 2017 | Toyota Cars & Trucks
Nov 25, 2015 | Toyota Cars & Trucks
May 16, 2011 | 2004 Toyota RAV4
Mar 24, 2010 | 2001 Toyota Highlander
Feb 07, 2010 | 2002 Toyota Sequoia
Jan 09, 2010 | 2004 Lexus GX 470
Dec 22, 2009 | 2001 Lexus RX 300
Jun 22, 2009 | 2007 Lexus GX470
May 20, 2009 | 2004 Toyota Solara
544 people viewed this question
Usually answered in minutes!