Question about 1993 Lexus Es 300

Open Question

1999 Lexus ES300 Reverse lights stopped working,

1999 Lexus ES300 Reverse lights stopped working bulbs good every other light on rear fine?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: 1999 lexus es300

This has been happening to my car as well. It typically happens when your oxygen sensors start to wear out. Mine does it once in a while and I have the local auto store reset it. Go to your nearest auto store and have them tell you what code it is and ask them to reset the OBD so the light goes out. If the light comes on right away and the code has to do with your oxygen sensors, have them replaced. There are three, two are easy to replace, one takes some effort as it is in a tough to get to spot. The dealer will charge you a fortune to replace them so do it yourself or through a local mechanic. It is a very simple task other then the access.

Posted on Jul 20, 2008

Ad
  • 840 Answers

SOURCE: Changing HID bulbs on a 2000 Lexus ES300

you should be able to get in behind headlight and change the bulb. The headlights have caps on them or twist the caps off

Posted on Jan 25, 2009

  • 51 Answers

SOURCE: 1999 lexus es300 how to find cylinder no.3 and 4 ?

the front bank is bank 2, the rear one is bank one. The cylinders go from the timing belt side to the right. So 3 is the middle on the back bank, and four is the middle cylinder on the front bank. They are both in the middle so just replace them.

Posted on Aug 26, 2009

GARYca
  • 672 Answers

SOURCE: LEXUS es300 oil light stays on oil level full

Check oil level sensor, replace if necessary. also, does your engine knock or make a tapping sound?

Posted on Mar 29, 2010

  • 1 Answer

SOURCE: Problem w/transmission Lexus ES300 1999

Is your O/D off? There should be a light under your speedometer, if it says "O/D OFF" than your car wont go to fourth gear. You can turn the overdrive back on on the knob that changes gears, theres a little button on the side. Press it and you should be good.

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Lexus ES300 Tail lights won't work


usualy there is a faulty earth to the bulb cluster remove them and clean all the conectors spray the harness and cluster with wd40 or similer put all bulbs back in and see if that works but i would go with a bad earth hope this helps ivan uk

Oct 23, 2012 | 1996 Lexus ES 300

1 Answer

Problem w/transmission Lexus ES300 1999


Is your O/D off? There should be a light under your speedometer, if it says "O/D OFF" than your car wont go to fourth gear. You can turn the overdrive back on on the knob that changes gears, theres a little button on the side. Press it and you should be good.

Mar 10, 2010 | 1999 Lexus ES 300

2 Answers

How do you replace the tail light bulb on a 2000 Lexus ES300?


2002 security light keeps coming on, is there any permanent fix
besides turning key on for ten minutes

Nov 05, 2009 | 2000 Lexus ES 300

2 Answers

Replacing third brake light bulb lexus 2001 es300


If you mean the 3rd as in lite on the rear dash , the cover pops off from inside the car.You must flex it it slightly from the sides or gently try to pop it with something wide , but flat like a putty knife. the bulb should be a common one

Sep 15, 2009 | 2001 Lexus ES 300

1 Answer

I would liekt o know wheere the fuse to the rear right blinker light is in my 99' Lexus ES300? Ccan some one help me with this?


there is not a separate fuse for the right rear turn signal, its probably the bulb. you will need to remove the tail lamp from the vehicle to get to the bulb

Sep 11, 2009 | 1999 Lexus ES 300

1 Answer

Replace brake light bulb 1999 lexus es300


The outside brake light bulbs are changed by removing the entire light module from the body. The module is held in place by two screws hidden by round plastic covers that pop out with a small screw driver. You will see the two round screw covers along the rubber moulding when you open the rear hatch. The outside edge of the module is plugged into the body with plastic prongs that will pop loose will you pull the module with your hands. The module will now only be attached by the slack bulb wires and you can twist the socket out of the module from the back.

Aug 05, 2009 | 1999 Lexus Gs 300

1 Answer

How to replace third brake light on 1997 lexus es 300


"To get access to the 3rd brake light:

- Place each hand against both sides of the plastic housing, and firmly grasp and pull the housing towards you. It might not budge at first, but it should move once you get a good grip on it.

- Pull the housing out just enough so that you can see the brake light bulb and stick your hand underneath. Ignore the speaker wires.

- Pull out the old bulb from the socket (it plugs in/out). Wear rubber gloves when handling the new bulb, and put the new one into the socket.

- Reverse the steps here to put the 3rd brake light back into place. Test out your brake light, and you're done" quoted from lexusk8 @ clublexus.com (great forum)

May 29, 2009 | 1998 Lexus ES 300

1 Answer

1998 lexus gs 300 brake light on but brakes are fine


If it a picture of rear of car lights it means you have a rear bulb out. If the light says BRAKE your emergency brake may be depressed one notch or low fluid level in master cylinder.

Mar 16, 2009 | 1999 Lexus Gs 400

1 Answer

Es300 lexus tail light alarm center portion out! no burn bulbs


We have a similar problem with a loose bulb. We tap in the light external light fixture and the bulb re-lights and the idiot light goes off.

Dec 30, 2008 | 2001 Lexus RX 300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...