Question about 1993 Plymouth Colt Vista

1 Answer

Starts fine & stops in 3-5 minutes or driving in 1-3 miles.

Engine starts fine then stops after 3-5 minutes of idle. If driven right after starting it will drive 1-3 miles before stopping. Either case, will not restart for 5 minutes up to 2 hours. have replaced front engine seal, timing belt, distributor in 8/09 and transaxles, water pump, transmisssion, fuel filter, spark plugs in 04/10. Problem seems to be the same as when I had the distributor replaced. what's next?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Did you replaced your whole distributor or just the cap and the rotor? Have you check the pressure on you fuel line it could be your fuel pump.

Posted on May 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Cadillac DeVille (has 110,000 miles on it) suddenly dies while driving. Starts and idles fine, but shuts off after driving only 1-2 blocks. What's wrong and how do we fix it?


There are many things that can contribute to this problem. It sounds like it may be ignition related. Possibly an ignition control module or ignition coil. The check engine light coming on while driving is the key to finding the problem. The light comes on when the computer finds a problem and will then store it in its memory. Have the codes checked for what the computer has found to be at fault and with a little diagnostics, should lead you to the problem

Jan 06, 2016 | 1991 Cadillac DeVille

1 Answer

Engine Power Reduced, Rough Idle


Driving around for a couple days- is one thing

Not caring at all & driving for weeks with a check light
on,hope for the best & no damage or at least something
you can afford

Low oil level by a few quarts,really,how's that possible?

Jan 24, 2013 | 2008 Pontiac G6

1 Answer

2002 escape 3.0 idle fluctuates and misfires when driving


No such thing as a tune-up

All you did was replace spark plugs which should be
done every 3 years

Oxygen Sensors get replaced at 100,000 miles which you
also did

You most likely have an intake gasket leak,smoke test
the entire Evap System & Engine

You also are have bad igniton coils

Jan 18, 2013 | 2002 Ford Escape

2 Answers

I have a 96 f150 5.8 4x4. Starts fine and runs fine, but when I start it after a 5-10 minute stop (when its warm), it will start fine but then die after a minute or so. It starts right back up and I hold...


Common issue on this year and engine, Do the cleaning outlined below.

Throttle Body Cleaning

You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jun 08, 2017 | Ford F-150 Cars & Trucks

2 Answers

BOUGHT BRAND NEW BATTERY NOW CAR CUTS OFF AND IDLES REALLY LOW


WHEN YOU DISCONNECT THE BATTERY THE ENGINE MANAGEMENT SYSTEMS PCM LOSES IT MEMORY INCLUDING ENGINE IDLING.THE COMPUTER WILL HAVE TO RELEARN THE OPERATING VALUES. IF CAR DOES A LOT OF STALLING AT STOP LIGHTS AND STOP SIGNS. GO BY FORD DEALERSHIP LET THEM REPROGRAM THE PCM.PROBABLY CHARGE YOU $35.00 DOLLARS. TO REPROGRAM PCM.

Jul 04, 2011 | 2006 Ford Five Hundred

2 Answers

Not Ready for Smog test


it is not how many miles but the type of driving.

here is a OBD2 drive cycle test.

Generic OBD II "Drive Cycle" Most OBD II ("On-Board Diagnostics II") diagnostic monitors will run at some time during normal operation of the vehicle.
However, to satisy all of the different Trip enable criteria and run all of the OBD II diagnostic monitors, the vehicle must be driven under a variety of conditions. The following drive cycle will (theoretically) allow all monitors to run on (??) vehicle. (Note: Drive cycle specifics vary by vehicle!)
  1. Ensure that the fuel tank is between 1/4 and 3/4 full.
  2. Start cold (below 86°F /30°C) and warm up until engine coolant temperature is at least 160° F (typically requires at least one minute; up to 3 minutes).
  3. Accelerate to 40-55 MPH at 25% throttle and maintain speed for five minutes.
  4. Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute.
  5. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes.
  6. Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute.

Jun 04, 2010 | 2001 Kia Sephia

2 Answers

Car will start fine but will shut off as soon as I place in gear.


Here are the most common causes of surges, stalls at stops, low erratic idle speed, rough idle and engine hesitation, it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 30, 2009 | 1991 Chevrolet Cavalier

1 Answer

'99 chevy Silverado Z71,5.3 engine.....will not rev when hot.....


try replacing your EGR Valve, or your Oxygen Sensor

Feb 10, 2009 | 2001 Chevrolet S-10

Not finding what you are looking for?
1993 Plymouth Colt Vista Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...