Question about Nissan Sentra

1 Answer

I changed head gasket on 91 nissan sentra and went back together with it and I can't seem to get it to fire. There is a blue connector on passnenger side of engine next to intake and can't seem to find where it go's. could this be the problem?

Posted by on

1 Answer

You will need to set your timing to 10 Degrees (for both the manual and automatic transmissions) The blue connector plugs into the harness, look for another blue plastic female connector and just snap it into place

Click on the link below to read more:

http://www.nissanforums.com/b13-91-94-chassis/72123-head-gasket-changed-engine-wont-start.html

Posted on May 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you Replace Head Gasket for 2002 Nissan Sentra GXE ?


Big difference between valve cover gasket and head gasket. To replace head gasket, you must dissamble top end of engine and send the head out to be resurfaced and then install new head gasket. If it is a leaking valve cover it is much easier. Simply dissasemble and then clean valve cover and top of head from all debris and remove all old gasket material. Tighten back down in sequence and do not over tighten. these small bolts can be overtightened easily so go in sequence just like when you tighten lug nuts by skipping one as you go around. 10mm bolts require about 10 pounds or less torque.

Jul 18, 2014 | 2002 Nissan Sentra

1 Answer

I have a 2001 nissan sentra, and it seems to have a common 2001 nissan sentra problem. i went to start her about 2 months ago, and she fired right up. drove around, went home and she sat til the next day....


Go over it, check the air filter, fuel filter, make sure your key isn`t bent. bent keys off set the chip and the car cant read it. next time take out the key and turn it around and try it again. let me know.

Apr 24, 2014 | 2001 Nissan Sentra

1 Answer

Overheating in really hot part of day and especially with Ac


The block sealer you used may have been too thick or too big. A leaking head gasket or cracked head is a rare cause for a cylinder misfire. Tryin putting a manufacture gasket back on and change the spark plugs. If that doesnt work, try checking your valves or pistons-- maybe you have worn valve guides or your cylinder wall is worn out.

Jul 12, 2009 | 2003 Nissan Sentra

2 Answers

Blue smoke on a 2001 nissan sentra


blue smoke indicates exsesivs oil in cylinders,may have worn valve seals or leaking piston rings, is there any lost in engine power?

Jun 21, 2009 | 2001 Nissan Sentra

1 Answer

Nissan Sentra Super sallon Coolant level reduce by 1 cm bioweekly


not frequently,maybe once a month. if the coolant is going down "drasticly",and no visible signs of a leak,then you have a bad head gasket..

Dec 25, 2008 | 2003 Nissan Sentra

2 Answers

Heater blowing cold air


My 05 sentra with 79k miles heat will warm up and then get cold after a mile of driving, we have tried to get the air pocket out, the mechanic stated he thought it could be a blown head gasket, another mechanic said it was a bad heater core. Any advice would be appreciated.

Nov 24, 2008 | 2005 Nissan Sentra

1 Answer

Hi, I have a 2001 nissan sentra gxe that is overheating. I have changed the thermostat, water pump and flushed the radiator. The radiator does not have a leak in it, but the car is still over heating. ...


hi. was just looking at your problem of (sentra) overheating and actually, i am a mechanic for nissan and have changed many head gaskets for this particular vehicle equipped with 1.8 liter motor and found that they are notorious for this problem of faulty head gasket's.Unless you did't properly bleed the system,which i doubt because you seem mechanically inclined since you already changed every other part of the system,i would't doubt that this is the problem.Anyway, by the time you read this, you have probably already found this out..Just thought i would let you know this info.Good luck!...by the way,if you haven't already changed you cam and crank sensors,do that too,before you get stuck and get the part's at the dealer!!!!-they are redesigned from the old one's!!just some advise to try to help you out!!! John from N.Y.

Jul 26, 2008 | 2007 Nissan Sentra 2.0 SL Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...