Question about 1995 Nissan Maxima

Open Question

95 Nissan Altima - wnat to pry apart main fuse box but how?

I have a 95 Nissan Maxima. main 140 Amp fuse is blown. It is suggested I take the main (under the hood passenger side) fuse box out and clean any corrosion that is on the connectors at the bottom. That means I have to get it off. Took off 2 large screws holding it to the frame. Used small screw driver to pry plastic joiners apart and now have 60% of it free. On the side closest to the car frame I can't see what joiners to pull apart to get the whole thing apart. Thanks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 2004 nissan maxima passenger side window will not roll up

you window must have slipped off the rolling pulley that pushes the window up or one of the plastic pieces is broken that holds the window.

Posted on Nov 02, 2008

Ad
  • 1 Answer

SOURCE: 1996 Nissan Maxima Bose Radio has no power

This
sounds funny but disconnecr the battery and then hook it back up-I did this and power was restored to my radio-I have no idea why this worked.

Good luck!!!!!!!!!

Posted on Dec 23, 2008

  • 42 Answers

SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel

This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal

Posted on Mar 20, 2009

TwinTurboZ
  • 78 Answers

SOURCE: Wont shift out of park unless I stick a screw driver in a small hole above gear shifter.

You must remove the console yes, and you need to replace the shift lock solenoid.

Posted on May 15, 2009

  • 1 Answer

SOURCE: Lost Fuse Box Diagram - Altima 2005 2.5L

i need to know what ENG CONT AND ENG MTG means on the fuse box of my 2006 altima.

Posted on Jan 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing 140 amp fuse in lexus gx 470


Replacing 140 amp fuse in lexus gx 470 - Fixya

www.fixya.com/.../t26021201-replacing_140_amp_fuse_in_lexus_gx_4...
24 mins ago - The battery in my lexus gx 470 needed to be replaced it was hooked up wrog and the 140 amp fuse was blown how do i replace the 140 amp ...

HOW DO I REPLACE THE 140AMP FUSE ON A LEXUS ...

www.fixya.com/cars/t24496313-replace_140amp_fuse_lexus_gx470
May 24, 2014 - HOW DO I REPLACE THE 140AMP FUSE ON A LEXUS GX470CAN"T GET THE FUSE BOX APART TO UNBOLT THE FUSE - Dodge 1997 ..

Dec 25, 2015 | Lexus GX 470 Cars & Trucks

1 Answer

Replaced main window switch now dashlights dont work 1998 nissan altama


check the fuse box for dash illumination fuse , did you disconnect battery when changing window switch? if not possible to have blown a fuse

Apr 26, 2014 | 1998 Nissan Altima

1 Answer

2002nissan3.5cylinderheadtorque



2_17_2012_6_58_18_pm.jpg

Fig. Cylinder head bolt loosening sequence - Altima & Maxima 3.5L engine

Install the cylinder head bolts and torque in sequence as follows:

  1. Step 1: 72 ft. lbs. (98 Nm).
  2. Step 2: Completely loosen all bolts.
  3. Step 3: 26-32 ft. lbs. (34-44 Nm).
  4. Step 4: plus 90-95 degrees clockwise.
  5. Step 5: plus 90-95 degrees clockwise.

2_17_2012_6_59_54_pm.jpg

Fig. Right cylinder head bolt torque sequence- Altima & Maxima 3.5L engine


2_17_2012_7_00_21_pm.jpg

Fig. Left cylinder head bolt torque sequence- Altima & Maxima 3.5L engine

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Apr 12, 2012 | Cars & Trucks

2 Answers

2002 nissan maxima 3.5 cylinder head torque


Hi there:

2_17_2012_6_58_18_pm.jpg

Fig. Cylinder head bolt loosening sequence - Altima & Maxima 3.5L engine

Install the cylinder head bolts and torque in sequence as follows:
  1. Step 1: 72 ft. lbs. (98 Nm).
  2. Step 2: Completely loosen all bolts.
  3. Step 3: 26-32 ft. lbs. (34-44 Nm).
  4. Step 4: plus 90-95 degrees clockwise.
  5. Step 5: plus 90-95 degrees clockwise.

2_17_2012_6_59_54_pm.jpg

Fig. Right cylinder head bolt torque sequence- Altima & Maxima 3.5L engine


2_17_2012_7_00_21_pm.jpg

Fig. Left cylinder head bolt torque sequence- Altima & Maxima 3.5L engine

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day

Feb 17, 2012 | Nissan Cars & Trucks

1 Answer

Torque setting head 2002 nissan maxima


Hi there:

2_17_2012_6_58_18_pm.jpg

Fig. Cylinder head bolt loosening sequence - Altima & Maxima 3.5L engine

Install the cylinder head bolts and torque in sequence as follows:
  1. Step 1: 72 ft. lbs. (98 Nm).
  2. Step 2: Completely loosen all bolts.
  3. Step 3: 26-32 ft. lbs. (34-44 Nm).
  4. Step 4: plus 90-95 degrees clockwise.
  5. Step 5: plus 90-95 degrees clockwise.

2_17_2012_6_59_54_pm.jpg

Fig. Right cylinder head bolt torque sequence- Altima & Maxima 3.5L engine


2_17_2012_7_00_21_pm.jpg

Fig. Left cylinder head bolt torque sequence- Altima & Maxima 3.5L engine

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 17, 2012 | Nissan Maxima Cars & Trucks

1 Answer

Where is the fuse for the window in a 94 maxima


All the electric windows are serviced by the same fuse, The fuse must be in the main fuse box. The position and function of the fuses is normally marked on the inside of the fuse box cover and also in the owner's handbook. If you don't come right with these, work your way through the fuses looking for a blown one. To ease your search the widows fuse it should be around 30 amps.

Mar 04, 2011 | 1994 Nissan Maxima

2 Answers

2006 Nissan Altima LH driver side headlamp will not work. Replaced bulb & still will not light. Fuse box diagram insn't marked for headlamps. what could be the problem?


you will find another fuse block under hood near windshield washer fill neck.remove the cover and it will show the location of headlamp fuses.most likely is a blown fuse.

Feb 20, 2011 | 2006 Nissan Altima

1 Answer

I got a jump for my 1996 nissan altima and the car runs but, there is no electricity working in the car. No horn, rpm switch, power windows/locks, interior lights, or radio working, I don't know what is...


At a guess I would say that the main fuse is blown. Look for it either at the battery terminal or alternatively, in the fuse box. It will be somewhere in the region of around 50 amps.

Jan 31, 2011 | 1998 Nissan Altima

2 Answers

95 Nissan Maxima GLE alarm/clock/radion memory don't work after..


Did you check the main fuse's in the engine bay ?
They live in a black plastic box , chunky looking things.
Let me know what you find.

Jun 27, 2009 | 1995 Nissan Maxima

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...