Question about 1992 Chevrolet Cavalier

Open Question

I can not find where in the engine comapartment where the Fuel Relay is located at. I've contacted AutoZone but they were about as helpfull as a brick wall.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump relay located on a 1988 olds cutlis ciera


I looked at wiring for the 2.8L engine. The relay should be under hood passenger side on strut tower, fender lining. If more than one relay and your not sure which is which, look at wiring diagram for fuel pump relay and compare wire colors.
www.bbbind.com
has free wiring diagrams.
www.autozone.com
also has free wiring diagrams.

Dec 11, 2015 | Cars & Trucks

1 Answer

Where is the fuel pump and relay located 2.5 4 cylinder cutlets sierra 1985 not getting fuel when I pour gas in throttle it starts


1985 Oldsmobile Cutlass Ciera 2.5L TBI OHV 4cyl

The Fuel Pump Relay is located: Under hood, passenger side, rear engine area, mounted on upper firewall.Here's a link to what it look's like. http://www.autozone.com/fuel-delivery/relay-fuel-pump/duralast-relay-fuel-pump/oldsmobile/cutlass-ciera/1985/4-cylinders-r-2-5l-tbi-ohv/841098_0_0_7784 Here's another link to replacing your fuel pump, SAVE 20 ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE

Jul 16, 2015 | Cars & Trucks

1 Answer

Location of fuel pump relay on a 94 skylark 3.1


http://www.autozone.com/autozone/parts/Duralast-Relay-Fuel-Pump/1994-Buick-Skylark/_/N-j0vmuZ8vdvu?itemIdentifier=221854_401011_10517_ The fuel pump relay is under hood, passenger side, rear side of strut tower, mounted in relay block on firewall corner.Click on link to see relay.

Sep 05, 2012 | Cars & Trucks

1 Answer

My fuel pump on my 99 cougar v6 only runs for a half second then shuts off I've replaced the filter , the pressure regulator valve , the pump and it still does the same thing . could I have a ecm prob


Generally, the computer only runs the pump long enough to start the engine and build oil pressure. After that, the oil pressure switch keeps the pump on, most of the time by supplying a ground to the fuel pump relay. This is a built in safety thing, when the engine isn't running, the fuel pump shuts off. Most public libraries have Chilton's manuals, or you could pick up a Hayne's manual at a store like Autozone. These books can help you locate the relay and oil pressure switch, as well as provide wire colors for your specific vehicle.

Nov 13, 2011 | Cars & Trucks

1 Answer

My car just stopped working it seems no gas is gettin to the engine but it used to stall alot not like oh s*** im out of gas but the stall when you press the gas and absolutely nothin happens then the car...


Here's a technique that works for me. Locate the fuel pump relay, in the fuse and relay panel. Pull the fuel pump relay and look at the bottom of the relay. You will see that the cover can be removed by carefully prying it off using a small flat blade screwdriver or an x-acto knife. Once the cover is removed, reinstall the relay. Have someone start the car while you watch the contacts on the relay. If the contacts close, the relay is OK. If you turn the key to on without starting the car, you car close the relay manually. (You can use your finger to close the relay. Listen carefully, at the fill tube with the gas cap removed. If the fuel pump is getting power you will hear the whine of the motor. If not then check the fuel pump fuse first then the 12 volts at the connector on top of the fuel tank. I've had a problem such as you described, where the car will start but stalls if you try to give it gas. I found that some GM's use a small (2 inch)section of rubber hose to connect the pump to the steel fuel line inside the tank. The hose splits which allows enough fuel to reach the engine, but not enough to run it under any load. The fuel filter should be replaced if it is suspect, but probably isn't your main problem. Hope this helps! Dano

Jul 31, 2011 | 1993 Buick Century

1 Answer

1996 plymouth voyager won't start replace cam sensor and crank sensor still won't start just turning over


Back to basics. You need spark, fuel, and compression (manifold vacuum). Before you replace any more parts, check to make sure that you have no stored codes. If your check engine light is on, retrieving the codes will point you in the right direction. If you have to, tow it down to your local Autozone. They will scan it for free! If the check engine light in not on, the problem is most likely the fuel system. So, locate the fuel pump relay under the hood next to the driver side front fender. Remove it and CAREFULLY remove the top by lifting the two clip tabs with a small screwdriver. reinsert the relay and crank the engine while observing the relay to verify that the relay pulls min. That is, that the contact moves. If it doesn't, check the fuse and the relay itself. (Swap the AC clutch relay, they're the same). If it does, try manually closing the relay with the key on while someone listens at the open fuel opening, (take the gas cap off first) If you don't hear the fuel pump running, it is probably the pump. Please note that I own a 97 voyager that is very hard to start, and I have often had to manually operate the fuel pump relay in order to prime the engine so that it will start. Hope this helps!

May 02, 2011 | 1996 Plymouth Grand Voyager

1 Answer

Im trying to find were the fuel pump relay located at on 1990 toyota camry


The fuel pump is controlled by the "Circuit Opening Relay" It is located under the Engine Electronic Control Unit (CPU) which is under the center of the dash.


Has this been helpfull? If so, please take a moment
to provide some feedback by rating my answer.

Jan 17, 2011 | Toyota Camry Cars & Trucks

2 Answers

Hey i have a cadillac sedan deville 1992 where is the fuel pump located


The fuel pump is located in the fuel tank. On these GM cars, the fuel tank must be dropped in order to change the pump. It is alos recomended that the fuel filter be changed at the same time which is on the frame of the vehicle, left side. the pump at autozone runs about $75 and don't forget the strainer for about $10. The filter runs about$10 also.

Mar 03, 2010 | 1992 Cadillac DeVille

1 Answer

How do you replace a new fuel filter for a Saturn Sw2 99' series?


Here is a link you will find helpfull and please rate my assistance in helping you thank you. This link will tell you how to do it and where it is located at.

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?partName=Fuel+System&pageId=0996b43f80370e8c&partId=0996b43f80370e8c

Feb 13, 2010 | 1999 Saturn SW

2 Answers

Where is fuel pump relay located


the relay is either located in the large fuze box under the hood, when u locate this fuze box open it and under the cover it will have a picture of where the relay is in the box, or its located on the fire wall under the hood on a rack with a couple of other relays. hope this is helpful please rate me

Jan 12, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1992 Chevrolet Cavalier Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...