Question about 1991 Pontiac 6000

1 Answer

Where is crank sensor on 1991 pontiac 6000 - 1991 Pontiac 6000

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Pontiac Master
  • 1,250 Answers

On right side of engine

where is crank sensor on 1991 pontiac 6000 - 4783480-s5q1xdv45kmkbwtygmekt3q5-1-0.jpg

Posted on Feb 05, 2015


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 34 Answers

SOURCE: where do i locate the heater core in a 1991 pontiac 6000le

The heater core is inside the heater case. It is the same plastic case that houses the blower motor. Usually they are replaced under the hood near the firewall or under the dash. I would look at the free online repair manuals provided by parts stores such as . They should have the info you need for your particular model.

Posted on Sep 22, 2009

  • 347 Answers

SOURCE: 1991 Pontiac 6000 LE ( Canadian ) Rear window de fogger not work

they have a relay also make sure conections are good on the window

Posted on Oct 24, 2009

  • 6826 Answers

SOURCE: 1991 Pontiac Grand Am 2.5 tries to turn over but

Yes it can.

Posted on Apr 05, 2010

Testimonial: "Taking it to the shop hopefully it will run. Thank you very much!!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1991 pontiac 6000 starts and idles but stalls when I push gas pedal ?

check the plugs because if they are worn enough it can cause this type of problem.also have the fuel pressure and volume checked as if these are not in spec then it also can cause this.the throttle position sensor(tps)if it has a bad spot in it can create this as well.there is a map sensor that can have an effect on how a car runs.

Nov 01, 2011 | 1991 Pontiac 6000

1 Answer

While driving SERVICE ENGINE LIGHT comes on periodically. Right before SERVICE ENGINE LIGHT there is a very slight and brief hestitation ( or downward idling ). SERVICE ENGINE LIGHT does come at stops...

Hi check it out. You may need to replace your speed sensor. I was having the same problems a year ago and my speed sensors finally went all the way out. Now my light doesnt come on anymore and the car runs better.

Jan 09, 2011 | 1991 Pontiac 6000

1 Answer

What should my idle rpm be for a 1991 pontiac 6000 le

nearly all motors ahould be about 800/900 but some of these big old motors with a big multicylinder engine will idle as low as 2/300

May 27, 2010 | 1991 Pontiac 6000

1 Answer

Cannot figure out how to test the crank shaft position sensor to see if it has caused recent ignition failure because the harness has three leads at the end that connects to the ignition modual and two...

If you unplug the crank sensor at the module and measure the resistance of the crank sensor. (the yellow wire and the black wire) The resistance of the crank sensor should be 900-1200 ohms.

May 17, 2010 | 1989 Pontiac 6000

1 Answer

Car starts then after few minutes will shut off and stall out

its possible the cam sensor or the crank shaft position sensor maybe broken or coming apart. the cam sensor is part of the timing chain.

Jan 02, 2010 | 1991 Pontiac 6000

2 Answers

Runs fine then it just stalls. Wait awhile and it runs fine then stalls again

Sounds like a crank sensor. That would be my starting point

Nov 11, 2009 | 1991 Pontiac 6000

1 Answer

1991 Pontiac 6000 LE ( Canadian ) Rear window de fogger not work

they have a relay also make sure conections are good on the window

Oct 23, 2009 | 1991 Pontiac 6000

1 Answer

Changed starter and now we get a revving/whirring sound

It sounds like the starter is not engaging the flywheel to crank it and is just spinning. If it were mine, I'd pull the starter out and see if anything looks strange and see if the starter gear moves easily.

Nov 20, 2008 | 1991 Pontiac 6000

Not finding what you are looking for?
1991 Pontiac 6000 Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides