Question about 2000 Mitsubishi Mirage

Open Question

How do I adjust my headlights on a 2000 mirage?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Emergency lights come on when headlights are off`


Have you been doing any work with anything that might mess with the wires to the headlights or emergency lights? And are the hazard run off of the same switch as the headlight switch?

Sep 13, 2013 | 2000 Mitsubishi Mirage

2 Answers

Where is the location of the flat transmission filter for a 2000 mits mirage?


Inside of the transmission. Remove the transmission pan and you will see it.

Jul 29, 2011 | 2000 Mitsubishi Mirage

1 Answer

I have a 2000 Mitsubishi mirage and my left turn signal on the rear stays on when I switch the head lights on I switch out all the bulbs and put a new, headlight -turn signal switch combo on so what else...


It sounds like a bad earth connection in the vehicle rear wiring loom. If you have a multimeter test for continuity of the earth wires with the globes removed to prevent any false readings. Check the earth wire that runs from the all the globe sockets in the left hand light unit and any connector blocks in the wiring loom near the light assemblies as well as where the earth wire is attached to the body. If necessary, remove, clean thoroughly by removing any corrosion or paint and re-attach securely.

Feb 16, 2011 | 2000 Mitsubishi Mirage

1 Answer

Looking to replace the alternator belt on my 2000 mitsu mirage.....there is no belt on the alternator, guess i lost it somehere on the way home, car ran for a bit, then conked out.....any advice or tips on...


I would replace the steering pump belt at the same time you do the alternator belt (buy both).
To take off the alternator belt .
First , take off the negative battery cable so you do not blow an expensive fuse on the positive battery cable clamp(or a block fuse under the hood). Facing the back of the car , reach UNDER the alternator and loosen the bolt on the bottom right side, now loosen the bolt on the adjuster block on top, you can now turn the adjuster bolt and move the alternator to change the belt.
To take off the steering pump belt on the front of the motor, you need to loosen the nut on the back side of the pulley it holds the adjuster pulley in place . With the adjuster pulley loose , you can use the adjuster bolt to move the pulley to adjust/take off the steering pump belt.

Jan 27, 2011 | 2000 Mitsubishi Mirage

1 Answer

HOW TO ADJUST HEADLIGHTS IN A 1997 MITSUBISHI MIRAGE


There are torex screws on under the hood above headlights you can use a 6mm / 12 point socket or wrench also

Jan 04, 2011 | 1997 Mitsubishi Eclipse

2 Answers

I need to replace the alternator belt on a 2000 mitsubishi mirage i would like a diagram please


If you have limited / no mechanical knowledge leave this to an Auto Technician.

This a relatively easy job.

Undo the alterantor lock nut (12mm ring spanner / socket wrench)
Undo the alternator adjustment bolt almost fully (Either 10mm / 12mm wrench)

Get under the car and loosen the main alterantor bolt using a 14mm wrench. Just loosen enough to move alternator, it is not to be removed.

Pull alterantor forward to slacken belt / remove belt.

Replacement is the opp of the above.

Ensure the MAX. deflection at the middle of the belt is only 12mm (1/2") after all redfitting is done.

Failure to have it this tight will wear it out very quickly!!

May 18, 2010 | 2000 Mitsubishi Mirage

2 Answers

Fuel pump relay for 2000 mitsubishi mirage


most newer veichles your feul pumps in your gas tank

Aug 22, 2009 | 1993 Mitsubishi Mirage

1 Answer

How can i change headlights for my honda accord 2000.i want to replace the headlights for my honda accord 2000 car. can i do myself amd how


open the hood and reach behind the lights. There should be a ring, turn this plastic ring until it stops and the bulb should come right out, theres probably a better explanation in your manual

Jun 20, 2009 | 1999 Mitsubishi Mirage

1 Answer

2000 Mitsubihi Mirage DE coup 1.5L -P.S. Belt


a225cad.gif
GENERATOR DRIVE BELT TENSION ADJUSTMENT/ PS

  1. Loosen the nut of the generator pivot bolt.
  2. Loosen the lock bolt.

Jun 05, 2009 | 2000 Mitsubishi Mirage

2 Answers

Sound system speakers


wire connection problem. part of the wire might be broken/cut. check the wirings from the radios to the speakers.

Nov 03, 2008 | 2000 Mitsubishi Mirage

Not finding what you are looking for?
2000 Mitsubishi Mirage Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...