I CAN'T FIND WHERE THE 93 FORD BRONCO SENSOR MODULE FOR THE SPEED OMITOR IS LOCATED AT CAN YOU HELP ME

Probly in the fuelpump module in tank. Buy a haynes manual for details

Fuel filter. Low fuel no power. Catalytic converter. no air out, no air in. loss of power.

Have you checked the rings around the cylinders? That might be it.

Hi there:
You have several engine sizes there:

1993 Ford Bronco Full Size 4.9 liter L6 VIN "Z"





1993 Ford Bronco Full Size 5.0 liter V-8 VIN "N"





1993 Ford Bronco Full Size 5.8 liter V-8 VIN "H"






Hope this hesl; remember to rating this answer.

i suspect a temperature sensor thats controlling the autochoke but have no product knowledge so i suggest that ask a direct question to emissionwiz as hes a ford dealer mechanic who will know for sure as to where the sensors are located

On 1995 Ford Truck Bronco 5.8L EFI 8cyl the Control Module-Ignition is located under hood, center, upper engine area, front of intake manifold, mounted on front side of distributor.



Fig. 1: A TFI-IV ignition module

Hope this helps (remember to rate and comment this free answer).

IT WOULD BE ON TRANSFERCASE OUT PUT SHAFT END.

I just had the same problem, today, check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down spark and fuel

i Have 96 Taurus, may help you. May be a little different on 93. good luck. please rate if this is what you need.
-----------------------------------------------------------------------------
3.0L (2V) and 3.0L (4V) Engine
The vehicle speed sensor (VSS) (9E731) is:

• a Hall-effect pickup that sends a signal to the powertrain control module (PCM) (12A650).
• able to provide the VSS signal which tells the powertrain control module vehicle speed.

Vehicle Speed Sensor (VSS) (Except SHO) Removal and Installation

1. Disconnect battery ground cable (14301) and positive battery cable.
   

1. Raise and suitably support vehicle on hoist. Refer to Section 00-02 .
   

1. Remove three bolts, seven nuts and Y-pipe assembly from vehicle.
   

1. Disconnect vehicle speed sensor electrical connector.
   

1. Remove vehicle speed sensor retaining bolt and vehicle speed sensor (VSS) (9E731) from transaxle.
   

1. To install, reverse Removal procedure. Tighten VSS retaining bolt to 3.4-4.5 Nm (31-39 lb-in). Tighten Y-pipe assembly nuts and bolts to 34-46 Nm (26-34 lb-ft).
   

What engine? Bronco or Bronco II