Question about 2003 Chrysler PT Cruiser

2 Answers

2002 pt cruiser, it stalled and wouldnt start, tried boosting it off and it still wouldnt start. the next day it started right up. checked battery, altenator and starter all work fine?

Posted by on

  • prettybla154 May 15, 2010

    2002 pt cruiser, it stalled and wouldnt start, tried boosting it off and it still wouldnt start. the next day it started right up. checked battery, altenator and starter all work fine?

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,619 Answers

Hi


Thanks for using FixYa. First of all you’ll need to check battery voltage, recharge it if it is low or jump start with another battery charger. Inspect, clean and tight both ends of all battery cables. Also check, clean and tight wiring connections. Check for voltage at relay. If relay has voltage but there is no "click" when key is turned to start, replace relay. Remove starter and inspect drive gear and flywheel teeth, replace damaged parts if necessary. Check to see if voltage reaches starter relay/solenoid when turn to start. If not, check for open P/N switch, brake or clutch pedal switch. Replace the parts which are defective. Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Posted on May 15, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

When you say you tried "boosting it" did the vehicle crank

Posted on May 15, 2010

  • prettybla154 May 15, 2010

    no it wouldn't crank.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2008 PT Cruiser: battery dead each morning, new battery, alernator & starter check ok. Starts after a boost each morning, starts at noon & at 5pm, but won't start the next morning. Been doing...


Put a test light on the negative battery cable with it unhooked from the battery touch the test light tester side to the negative terminal on the battery .. the test light will illuminate now start pulling fuses .. the test light will dim as u remove the drain ... check and see witch fuse dims the light the most .. check that circuit... its running your battery down

Jan 28, 2014 | 2008 Chrysler Pt Cruiser

1 Answer

2002 windstar wouldnt start jumped and started. then no start


Hi, chances are you have at least one bad battery cable. Check them with an ohm meter. If you have any resistance in your reading, say above 0.02 change your cable. Hope that helps.

Sep 22, 2017 | Cars & Trucks

1 Answer

2002 ford windstar first wouldnt start, jumped and started, drove 200 miles and turn


You need to have the factory security system scanned, it is most likely locking you out due to a fault.

Jul 07, 2017 | 2002 Ford Windstar Cargo

1 Answer

Pt cruiser not starting


Try testing the starter solenoid and the relay.

Jun 26, 2017 | 2002 Chrysler PT Cruiser

2 Answers

EXACT SAME PROBLM


either your cat has melted. Or your trans is shot

Aug 15, 2009 | 2002 Chrysler PT Cruiser

2 Answers

2002 PT cruiser trying to start with no key!


Sounds like a short somewhere. Check the wiring around where he put the radiator in and make sure nothing is pinched, chafed, pierced or otherwise out of place.

Jul 22, 2009 | 2002 Chrysler PT Cruiser

1 Answer

2002 PT cruiser trying to start with no keys!


I would check your wire harness. The starter is close to where you would be working on the radiator. I have not had the pleasure to put one in but i know its a tight squeez in there.

Jul 22, 2009 | 2002 Chrysler PT Cruiser

1 Answer

Pt idle went crazy and car died now throwing codes


start by checking all the fuses inside the car and under hood

Nov 09, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...