Question about 1993 Mazda MX-6

1 Answer

Check engine light

Mazda 1993 mx6 check engine light go on while driving car runs good and then the next time I start the car the check engine light is off ???

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 143 Answers

Sounds like an O2 fault poss if it was a hard code the engine light would be stuck on so sounds like another sensor in the circuit is doing two jobs while the sensor that throws the light on has failed get the diagnosic code if any get back to me

Posted on Jun 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

96 mazda mx6 buzzing sound when tryng to start will not turn over has new starter and battery


No Crank, No Start Diagnosis - EricTheCarGuy - YouTube

? 12:22
https://www.youtube.com/watch?v=BrqkhZmDnHQ
Feb 26, 2012 - Uploaded by EricTheCarGuy
Visit me at http://www.ericthecarguy.com/ Whenever you have ano start condition when attempting to start your ...Missing: mx6

Why My Car Won't Start? - Reasons and Solutions

www.myautorepairadvice.com/car-wont-start.html
Before I even put the key into the ignition I hear a clicking noise on the right side ...Everything is turning over, but my car won't start. ... I just replaced the starter, battery, and alternator on my 1994 Nissan Sentra. ... (1998 Mazda Millenia 2.5L) ... This is the second time this has happened, and both times I started the jeep to ...Missing: mx6

How To Diagnose A No-Start ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous

Mar 4, 2006 - 2 posts - ‎2 authors
Diagnosing a No-Start I've been seeing a lot of No-Start related ... II - The car cranks, but just won't start. ... Stock fuel pumps will emit a faint buzzing or whining noisewhen they ... You'll hear the clicking each time the injector fires. .... You'll want to check that spark is getting to the engine as its turning over.Missing: mazda ‎mx6

Hard Starting, Any Advice? - Mazda626.net



Jan 31, 2016 | Mazda Cars & Trucks

1 Answer

I have a 93 Mazda mx6 Ls... Everytime I step hard


When my MX6 was doing this it turned out to be an hydraulic leak from the clutch master cylinder, which runs on the same fluid reservoir as the brakes. Clutch master cylinder replaced and all good again!

Apr 10, 2012 | 1993 Mazda MX-6

1 Answer

Where is my diagnostics connection located on my 93 mazda mx6 4 cylinder?


For 1993 Mazda MX-6 2.0L MFI DOHC 4cyl the OBD Diagnostic Link Connector is located: Under hood, driver side, upper engine area, passenger side rear of air filter housing, mounted next to airflow meter connector.

Hope this helps (remember to rate this free answer)
.

Jun 04, 2011 | 1993 Mazda MX-6

1 Answer

Hello there,mate has a MX6 1993 auto what happens is intermitted driving along and the motor stops(kills) not out of fuel...you stop push the auto back into park and the car will start so away you go...


No one checks wires. Start the engine and start wiggling the wiring harness at different points. If it dies on you then you have found the general area to look. then you will have to go to wiggling one wire at a time. Time consuming at best, but not hard. Just a note, wires tend to start breaking right at the back of the plug

May 19, 2011 | 1993 Mazda MX-6

1 Answer

Transmission 1993 mazda mx6


did you replace the engine? if so, you should check you reinstalled the shift links correctly with the correct bushes.

Jun 18, 2009 | 1993 Mazda MX-6

1 Answer

Mx6 not running right


there is an idle valve on the throttle body. it opens to keep a cold engine running, then closes when the engine warms up. if it sticks open, car will run good for a few seconds then stall the warmer it gets

May 27, 2009 | 1993 Mazda MX-6

1 Answer

Fitting a clutch to mazda mx6


It's easier to remove the engine but if you have a hoist and good gears you might get away without removeing the whole engine.

Mar 22, 2009 | 1993 Mazda MX-6

3 Answers

1994 mazda mx6 problems


It has a transmission problem. take it in for a scan. That should reveal the possible causes too.

Rate this

Mar 20, 2009 | 1994 Mazda MX-6

1 Answer

Mazda mx6


did you try replacing the ignition module?
every time that happened to me, it was exactly that. I have found an inexpensive way of repairing this.

Jul 27, 2008 | 1993 Mazda MX-6

Not finding what you are looking for?
1993 Mazda MX-6 Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...