Question about 2007 Chevrolet Tahoe

Open Question

NEED TO REMOVE SUN VISOR - 2007 Chevrolet Tahoe

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Sun visor on 2005 Nissan Murano won't stay up/falls down

I resolved this same problem on my 2004 Murano after also being told that it ($350 Visor) was not covered under my extended warranty. This problem is primarily caused by the heavier than normal visor. It cost me a total of $2.69 and about 30 minutes to fix.
To resolve this problem follow the following steps:

1) Go to the hardware store and purchase the Velcro package that contains (2) 18”, 1/2 inch strips (I chose the beige color since I have a tan interior) 2) Using a small screw driver, carefully pry off and remove the small cover that hides the mounting screws for the Driver’s visor. 3) Remove the 2 Phillips screws and drop the visor down slightly so that you can unplug the wires that go to the visor light and now remove the visor 4) Using the plastic velcro strip ONLY , (NOT the fuzzy strip), trim the end of the strip so that it will fit under the visor mount and also punch a small hole in that end of the strip so that one of the screws will go through it. (There is NO NEED to remove the adhesive backing from the Velcro strip)
5) Carefully mount the visor so that one of the mounting screws also goes through the Velcro strip 6) Be sure that the sticky side of the Velcro strip faces down or towards the visor
7) Once the visor is loosely mounted, pull the Velcro strip slightly and then tighten the 2 mounting screws securely. 8) Once mounted, hold the Velcro strip against the headliner and then raise the visor against the strip and the headliner and it SHOULD stick in place since it can’t drop down because one end of the Velcro strip is secured to the visor mount 9) Trim the exposed end of the velcro strip so that only 1 inch is exposed (or less) in case you need to lower the visor at a later time. (I removed a half inch of the backing and folded the exposed end on itself so that it's easy to grasp.) In this way you don’t have to glue anything to the headliner OR the visor.

(If your visor is a vinyl material, you will have to stick/glue the fuzzy velcro strip to the top side and/or edge of the visor so that there will be something for the plastic strip to stick to)

I hope this helps others…. It works for me! (and it sure beats $350!!)


Scott99

Posted on Jan 30, 2009

chuck943
  • 783 Answers

SOURCE: broken sun visor

On the plastic cover take a small screw driver and pry one of the open ends, in other words if you look at the cover carefully it is shaped like a U, pry on the top right side of the U to un-snap then rotate or twist the cover to remove.Then you can get to the screws that hold it into place/

Posted on Mar 25, 2009

  • 202 Answers

SOURCE: Sun visors won't stay flipped up.

most of the times on the visors if you look at were it mounts on the car you will see a small screw this is a set screw and if you tighten it just a little bit it should hold your visor up for you. but not all vehicles have a set screw as iam talking about. and if the impala dosent you need to get a compleat new visor
hope this helps you out

Posted on Apr 30, 2009

pixeldawg
  • 71 Answers

SOURCE: sun visor replacement

You unscrew the two bolts and gently take the visor off the mount. There will be a wire attached that has a plastic male/female connection that can be pulled apart. Do this gently. The wire is the power connection for the vanity light located within the visor.

Posted on Jun 03, 2009

  • 2976 Answers

SOURCE: driver side sun visor falls down

If you have anything on top of the visor, remove it. If there are any screws visible near the pivot rod, tighten them. You can remove the visor and slightly bend the pivot rod, inside the visor. You can just buy a new one and replace it yourself. It's only a few screws.

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove a sun visor in a 2015 jeep cherokee


unclip the sun visor from the "latch" side. Using a flathead pocket screwdriver gently pry the plastic shroud away around the hinge side. This will expose the bolts for the sun visor. Remove the weatherstripping partially from around the door if equipped with grab handles gently pry the covers off the hinges with pocket screwdriver and remove bolts (t30) partially remove cover from clip for sun visor and remove bolt (t20). Pull firmly directly out on a-pillar to unseat from pillar. Unscrew the three bolts from sun visor hinge side and gently unseat from wiring guide. Reaching above headliner gently guide wires for sun visor down through headliner and detach from harness.

Mar 05, 2015 | Jeep Cars & Trucks

1 Answer

How to remove sun visor rod 1005 mustang


Interference fit pull and twist if the rod is metal freeze visor and remove as suggested.

Apr 10, 2014 | 1995 Ford Mustang

1 Answer

2001 burick regal how to install sunviser


Its not that difficult to remove and replace sun visor.You just require few basic tools and new sun visor.For step by step procedure click the link below follow the steps and diagrams:-----
http://www.howtorepairguide.com/2013/09/how-to-replace-sun-visor-on-2001-buick.html
---------
This should help.
Thanks.

Sep 30, 2013 | Cars & Trucks

1 Answer

How to replace 2007 Kia Sportage sun visor


I forced a small nail between the visor rod and the tube (or whatever) the rod goes into in the visor itself. That created enough tension or drag to hold the visor and keep it from drooping. The visor now works in all three positions.

Feb 18, 2012 | 2007 Kia Sportage 2.7

2 Answers

How do I remove the 2007 kia optima sun visor?


Look at the plastic plate that the visor arm comes out of. There are screws underneath the plate. You need to adjust these screws, and that should take care of the problem.

Sep 25, 2010 | 2007 Kia Optima

1 Answer

Need to repair/replace broken sun visor vanity mirror hinges on 2005 Corvette.


i would go to your nearest dealer and order the sun visor you will need a 15 torx bit three bolts remove and replace you should be able to handle this repair yourself and save about 100 bucks good luck

Nov 27, 2009 | 2005 Chevrolet Corvette

1 Answer

Driver side sun visor falls down


If you have anything on top of the visor, remove it. If there are any screws visible near the pivot rod, tighten them. You can remove the visor and slightly bend the pivot rod, inside the visor. You can just buy a new one and replace it yourself. It's only a few screws.

Sep 16, 2009 | 2005 Nissan Murano

1 Answer

Horn not working in my 2005 mercedes clk500


Sun visor lights,... remove the sun visor clips you will find a copper insert inside the clip if this has broken (they do) you will need to replace them they 're about $12-15 ea. put them in & open your mirror "Gorgeous"
For the horn check the wire leads on the horn they are probably loose

May 20, 2009 | 2005 Mercedes-Benz CLK

1 Answer

Sun visor droops down 2002 ram 1500


where the visor attaches to the roof there should be a plastic "cover" it can be removed but be careful to not break the tabs. You should be able to tighten the visor

May 05, 2009 | Dodge Ram 1500 Cars & Trucks

1 Answer

I need to replace the passenger side sun visor....how?


I think you are talking about the sun visor for the windsheild, most cars of this erra the visor is held in place by 3 screws. after you take them out if there is some kind of light there will be a plug to unplug.

Feb 26, 2009 | 1997 Toyota Camry

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...