Question about 1993 Mercury Villager

1 Answer

Ran out of gas. vehicle started, ran, drove home,

Ran out of gas. Vehicle started ran drove home turned off would not restart. Is there a ran out of fuel procedure/fuel pump reset. Does sound like fuel pump is working. Dirty/clogged fuel filter

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

The fuel pump runs for 5 seconds when you turn key to ON. It runs all the time whie cranking and after engine starts.

Spray some starting fluid into throttle body & see if it starts then. If yes, pump may be bad. Can you hear pump run in fuel tank?

go here

http://groups.yahoo.com/group/villagerquest/

Posted on May 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy truck stalled on freeway after buying gas at a speedway station. Was it bad gas or fuel filter/fuel pump problem?


Good question. All you can do is hook a line up to the fuel rail to get some gas so you can inspect it. If the gas looks ok they you probably have either a fuel pump problem or ignition problem.

Aug 21, 2014 | 2004 Chevrolet Avalanche

1 Answer

Won t start


run the fault codes and look for faulty cam/ crank position sensor as this is indicated by the backfire/hard start and lower idle RPM. Check that battery terminals are clean and tight..

Sep 22, 2013 | Pontiac Montana Cars & Trucks

1 Answer

I RAN OVER A CURB AND DENTED MY GAS TANK. A CANISTER FELL ON TO THE GROUND.......I WIRED IT UP AND DROVE HOME QUESTION.......WHAT IS THIS CANISTER FOR AND CAN I ELIMINATE IT?


You can not eliminate any thing off the assy line on any
vehicle built since 1980

All Emissions Related-- has to be there if you have inspection
to go to, or expect a computer controlled vehicle to even work

Charcoal Evap Canister

Feb 12, 2013 | Lincoln Town Car Cars & Trucks

2 Answers

2005 Chrysler PT Cruiser was running and after putting a couple of Gallons of Gas in the tank and continurd driving, all of a sudden the vehicle seemed to loose execleration power and would not start or...


I HAD SIMILAR PROBLEM MY 2005 PT SUDDENLY JUST SEEMED TO CHOKE DOWN AND PUSHING ON GAS PEDAL MADE IT WORSE SO I LET UP ON PEDAL AND THEN SLOWLYMPH ACCELERATER BUT I WOULD ONLY GO ABOUT 50 MPH AND THE ENGINE LIGHT CAME ON I CHECKED OIL IT WAS FINE I THEN PUT A CAN OF SEA FOAM IN GAS TANK AND DROVE SLOWLY A WAYS THEN SPEEDED UP IT RAN FINE SEEMED TO BE DIRTY INJECTORS OR FUEL PUMP. I WNT ON HOME THE ENGINE LIGHT STAYED ON THE NEXT MORNING THE ENGINE LIGHT WAS OFF AND IT HAS RUN FINE EVER SINCE

Oct 19, 2012 | 2005 Chrysler PT Cruiser

2 Answers

Just turns off on it's own, Wait 60 sec. restart press pedel it dies.


This engine is electronically controlled so the first thing that must be done here is to have the systems control computer tested for fault codes and then do the proper diagnostics based on those codes.

Jun 07, 2012 | 1995 Plymouth Voyager

1 Answer

Ran out of gas. vehicle started, ran, drove home, turned off, would not restart. Is there a ran out of fuel procedure/fuel pump reset. Does sound like fuel pump is working. Dirty/clogged fuel filter


No, there isn't a reset. When you run out of fuel, after refilling turn your key on without starting the vehicle. You should hear the fuel pump working for a couple seconds. After the pump stops then try to start the vehicle. Because you could hear the fuel pump working, it is possible that your fuel filter is dirty/clogged. I hope this helps.

Mar 21, 2010 | 1993 Mercury Villager

1 Answer

2004 Ford Taurus, problem started last night. Drove to store, came home & parked. Tried to restart to park closer to curb and would not start. Engine did not turn over. Got low oil pressure message,...


Well your vehicle is indicating a problem, did you or your husband check the oil quantity? If it is low replenish the quantity. Also your battery seems to be failing, when you park it for a long time it will gain a little bit of power, thus when you come outside in the morning it would be better off then if you turned off the car and ran into the gas station to refuel and tried to take off. This shouldn't be a problem if your alternator is working properly and charging the vehicle while you drive. You may want to have your husband remove it and bench test it at a Checkers/Autozone or a local auto parts facility.

If you have more details, or questions email me at

xxsodasipperxx@yahoo.com

Dec 17, 2009 | Ford Taurus Cars & Trucks

2 Answers

Stalls / Dies / dead


this engine fuel pump prassurae low. it fuel pump celan. Your problem sovel

Jul 13, 2008 | 2003 Ford E150

Not finding what you are looking for?
1993 Mercury Villager Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...