Question about 2005 Ford F 350 Super Duty

1 Answer

How do you install a water pump in a ford f 450 6.0 ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,970 Answers

6.0L Diesel Engine

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. With the vehicle in Neutral , position it on a hoist.
  3. Remove the radiator and shroud assembly.
  4. Disconnect the cooling fan electrical connector. Unclip and position the fan wiring aside.
    NOTE Use a hole in the fan hub to prevent the fan from turning.
  5. Using the hub tool, loosen the cooling fan and clutch.
  6. Remove the cooling fan assembly.
  7. Remove the stator bolts and the stator.

    how do you install a water pump in a ford f 450 - 8ac47ee.jpg
    Fig. Remove the stator bolts and the stator-6.0L Engine
  8. Rotate the accessory drive belt tensioner clockwise and position the drive belt aside.
  9. Remove the bolts and the coolant pump pulley.
  10. Remove the bolts and the coolant pump.
  11. Remove and discard the O-ring seal.
  12. Clean and inspect the coolant pump mounting.

    3ed0f4d.jpg
    Fig. Water pump mounting-6.0L Engine
  13. To install, reverse the removal procedure.
  14. Observe the following torques:
    Stator bolts: 30 ft. lbs. (40 Nm) Pulley bolts: 23 ft. lbs. (31 Nm) Water pump bolts: 17 ft. lbs. (23 Nm)

Hope this help.

Posted on May 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace a water pump on a 2004 ford taurus


Wanda, Check out the video and links I posted to see how to remove and replace Taurus water pump.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to Install Water Pump Ford 3 0L V6 FWD WP 9038 AW4094
Ford Taurus Water pump Replacement
Need step by step water pump change
2004 Ford Taurus water pump Google Search

May 31, 2016 | 2004 Ford Taurus

1 Answer

Cost of fuel pump for 99 ford 150 6litre


This cost is usually about $300 to $450, plus installation.

Apr 12, 2011 | Ford F-150 Cars & Trucks

1 Answer

1994 ford e-450 shuttle bus 7.3 liter non turbo


change the delivery fuel pump right before the injector pump should 100% solve the problem. thanks

Mar 26, 2010 | 2009 Ford F-450 Super Duty

2 Answers

I have a 1999 Ford SHO that needs a new waterpump. I need to know how to replace it and where I can get a schematic of it. Do I need a special tool kit to do it? I'd also like to know where I can get the...


www.autozone.com

They can get all the parts. They also provide haynes repair manuals, any special tools (probably not required for this vehicle) and any special disassembly instructions.

I hope this helps.

Mar 11, 2010 | 2001 Ford Taurus

2 Answers

Where is the fuel pump located in the engine?


GAS POWER IF SO ONE ONE OR TWO TANKS
IF ONE IN THE TANK OF TWO LOW PRESSURE PUMP IS IN THE BACK TANK OR SIDE TANKS
THEN THERE IS A HIGHPRESSURE PUMP IN LINE TO THE ENGINE

Mar 02, 2010 | 2008 Ford F 450 Super Duty

2 Answers

2008 Ford F450 fuel pump relay fuse keeps blowing.


the fuel pump and radio are not on the same circuit, most liokely the fuel pump is shorted, that is the most common cause, get under the truck and disconnect the fuel pump connector at the tank, if the fuse doesn't blow then u need a new pump.

Dec 05, 2009 | 2008 Ford F 450 Super Duty

1 Answer

How to reset service soon light 2000 ford 450


The computer should have turned the light out if you installed a new sensor,unless you still have a faulty sensor,You need to have it put on a drb to check for current codes.

Nov 18, 2009 | 2001 Ford Super Duty F 450

1 Answer

2002 ford taurus wtaer pump


Removal & Installation 3.0L (2V) To Remove:
  1. Drain the engine cooling system.
  2. Loosen the water pump pulley.
  3. Remove the bolt and the nut and position the roll restrictor bracket out of the way.
  4. Remove the accessory drive belt.
  5. Remove the generator.
  6. Remove the bolt and the accessory drive belt tensioner.
  7. Remove the nut, the bolt and the support bracket.
  8. Remove the bolts and the water pump pulley.
  9. Disconnect the water pump inlet hose and the crankshaft position sensor electrical connector.
  10. Remove the bolts and the water pump, and clean the sealing surfaces
To Install:
  1. Install the water pump. Tighten bolts in the sequence shown:
    1. Tighten numbers 1-7 to 18 ft.-lbs. (25 Nm)
    2. Tighten numbers 8-12 to 89 in.-lbs. (10 Nm)
    3. Connect the crankshaft position sensor electrical connector and the water pump inlet hose
    4. Install the support bracket.
    5. Install the accessory drive shaft tensioner.
    6. Install the generator.
    7. Install the roll restrictor bracket, bolt and the nut.
    8. Install the water pump pulley.
    9. Install the accessory drive belt.
    10. Connect the battery ground cable.
    11. Fill the engine cooling system.

9de9feb.gif
Water pump bolt torque sequence (3.0L (2V) engine)

Jul 04, 2009 | 2002 Ford Taurus

1 Answer

Location of fuel pump relay on e-450 v-10?


The Fuel pump relay is in the Power Distribution Box under the hood, it is relay K. If it is the fuse then fuse 17 in the PDB.
It could also be the cut off switch, which is either under the dash above the brake pedal or behind the passenger kick panel

Feb 20, 2009 | 2001 Ford Super Duty F 450

Not finding what you are looking for?
Cars & Trucks Logo

1,076 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...