Question about Ford Mustang

1 Answer

I have a 3.8 V6 in my mustang.My AC compressor dose not engage.I checked the wire from the compressor too wear it gose into the hornnes.Not getting power.Then I checked the back of the switch.I found the perpple operating wire.I followed it all the way to the passenger side. And moved the clove comparment & side panel.I am getting power all the way to that side.what sould I check next or change.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,970 Answers

Sounds like a bad pressure switch or low on freon; also, try this tess, if the blower is completely dead and is not providing any air movement, the cause could be in the resistor block for the fan motor or the fan motor.

1.- If you have one or more blower speeds, the problem is the Resistor Block. This part (resistor block) controls the various speeds of the blower motor. It is located on the passenger compartment side of the blower housing and can be replaced in few minutes. You can find the part online for around $10.

2.- If you do not have any speeds, you should verify the Fan Motor works by pulling it and connecting it to a 12 volt DC power source. To pull the fan motor, you will have to remove the glove box to gain access to the 3 or 4 screws that hold the fan in place, although I did it without removing the glove box. The motor is attached to a large mounting plate that is at the bottom of the air plenum located behind the glove box. If you look up from the passenger floor you will see the motor hanging down. Once the connector is disconnected and the screws are out, you will have to turn the mounting plate to allow the motor to drop. Keep in mind the position as you pull it down as it needs to go back in the same twisting fashion.

Tell us news.

Posted on May 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AC not working


buy a new one. It will be best.

Aug 11, 2012 | 2002 Ford Mustang

2 Answers

I have a 2001 Ford Mustang V6, the ac is blowing warm air. We checked the refrigerant and it is full. The ac compressor will kick on for a few seconds and then kick off. Why is the compressor not staying...


it's either low (in spite of your readings) or your a/c clutch is not working correctly or you have too big an air gap in the clutch.
First, just disconnect the 2 pin connector from the a/c pressure cycling swithc and jumper the 2 pins with a wire to force the clutch to stay engaged. See if it blows cold then, and stays engaged. You can run this way for about 15 minutes before you have to pull the plug.
report reulsts.

please don't forget to rate.

Sep 01, 2011 | 2001 Ford Mustang

1 Answer

AC clutch will not engage


Usually when AC clutch doesn't engage is symptom of low freon. It's a safety feature so you don't burn up compressor. Compressor is lubed by freon and oil. Check freeing levels before replacing anything. Other things to check -fuse (yes that simple, they pop when freon gets low too, when compressor has to work harder than normal) If that doesn't cure issue then have a competent shop look at it... they'll find obstruction, leak or moisture in system in a heartbeat.

Feb 26, 2011 | 1998 Ford Mustang

1 Answer

V6 1994 ford mustang.engine wire harness


Sounds like you need to visit a salvage yard.

Jul 27, 2010 | 1994 Ford Mustang

1 Answer

98 Mustang v6 - no AC


Make sure the radiator pressure cap is the correct one and that the hose is not soft--check the lower hose and heater hoses for softness as well. They should be firm, but not hard or cracking. The temperature sensor is reporting normal operating temperature, so it and the thermostat are working correctly (hot water would blow out of the radiator if it were stuck). Check the cooling fan for free turning and no noise. Check it's grounding connection. Check the fuse box for blown fuses to the fan and to the A/C compressor. Make sure all the relays and fuses are firmly pressed into their sockets. Check the A/C compressor clutch winding for resistance--should not read infinity. Does the blower motor for the heater/A/C run when either is turned on? The A/C switch on the dash may be defective.

Sep 08, 2009 | 1998 Ford Mustang

1 Answer

1999 Mustang Cobra and ac suddenly went out. R134 level @100#. compressor clutch does not seem to be engaging. wires look OK. any suggestions?


Chek compresser fuse. Feel the front of the compressor while car is off and see if the compressor clutch moves by hand. If it does not move by hand, You will need a new compressor, if it does move freely by hand it is a compresser fuse blown

Aug 18, 2009 | 1999 Ford Mustang Cobra

1 Answer

AC wont work on 1998 ford mustang V6.


there must be a faulty wiring in your airconditioning system, try to see an aircon technician for trouble shooting

Jul 03, 2009 | 1998 Ford Mustang

1 Answer

Ac just quit


how much pressure do you have? low freon will cause compressor to stop running. do you have gauges to check?

Jun 14, 2009 | 2000 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...