Question about 2001 Chrysler PT Cruiser

1 Answer

I change the radiator of my car and now it does not want to start.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

Most likely you unplugged some sensor or switch. Does it try to crank, if it doesn't make sure the battery is hooked up right and you have power to the starter. If it cranks make sure you plugged all sensor, even if you didn't unplug them to begging with.

Posted on May 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1996 Cadillac fleetwood had a leacing radiator so I changed it and now it won't stop overheating any tips


Make sure that the thermostat is working properly. It is a good idea to change the thermostat when you change a radiator. How long does it take to overheat? You can leave the radiator cap off, start the car and wait for it to heat up and see if the fluid is pushed into the radiator. If not and the car overheats then you know that the thermostat is bad.

Sep 11, 2016 | 1996 Cadillac Fleetwood

1 Answer

Temp gauge reading hot fan not starting at right temp


is your fan working for the radiator? you will have to make sure it's coming in, a next factor could be your radiator needs to be service.

Feb 16, 2014 | Holden Barina Cars & Trucks

2 Answers

I have a Bmw C318 and when I am stuck in traffic jam my radiator fan is not running enough to cool the engine and i changed the thermostat and the radiator fan new but remained the same.And when i start...


Check the temp. sensor with a digital voltmeter.never use a test light on a comuterized car.should read same voltage on both terminals when fan energized. Highly suspect coolant temp. sensor @ radiator.

Nov 08, 2013 | BMW Cars & Trucks

2 Answers

My Kia Spectra Wont start after over heating


are the timing marks al in alignment if you changed the belt..also some systems require to be reset on the computer if the codes are still present.. take the negative cable off completely with the key in the run position.. then shut the key off and reconnect the negative..turn the key to run for a few seconds to allow all the factory presets to align.. then retry to start..

Feb 24, 2013 | 2005 Kia Spectra EX

1 Answer

Changed water pump on rav4 and now it won't start due to immobiliser how do I reset that


With the engine off and cold, open the hood and locate the vehicle's radiator and water pump. Remove the radiator cap.Install a pressure tester on the radiator. Apply the pressure indicated on the radiator cap or in the owner's manual. Inspect the water pump for leaks. Remove the pressure tester. Place a drain pan under the radiator. Open the drain valve or remove the lower radiator hose to drain the cooling system.-----------------------------------------------------------------------------------
CARPROG FULL V4.01

Jan 28, 2013 | 2009 Toyota RAV4

1 Answer

What causes 1991 toyota camry to over heat? we put a new radiator in it last year cause the radiator got cracked. but it didnt start overheating til this year. so we changed the thermostat thinking it...


Change the radiator cap, it may be the wrong pressure rating which will cause the coolant to boil at a much lower temperature than designed.

Nov 18, 2009 | 1991 Toyota Camry

2 Answers

A3 2.0 TDI changed radiator, how do you bleed the system


If you have no radiator cap that can be removed, you will probably have to do repeated cycles of engine temperature and just add coolant to the overflow until the engine stops draining it. This isn't like a hydraulic (brake) system so the chance of leaving bubbles behind is far less.
With a radiator cap, it's pretty simple; run the engine until the coolant is visibly circulating and add coolant as the level drops.

Oct 08, 2009 | 2005 Audi A3

1 Answer

Radiator fan runs when car is cold but not hot


Try running a scan.

There must be a sensor problem though.

Apr 29, 2009 | 2001 Mitsubishi Diamante

1 Answer

Coolant problems 2000 vw jetta


plastic impeller on water pump has come adrift

Dec 18, 2008 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2001 Chrysler PT Cruiser Logo

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...