Question about 1993 Dodge Dakota

1 Answer

Clattering in my dodge dakota 1993 inside the motor

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

3.9? From the factory they don't have timing chain tensioners but they are available aftermarket.

Posted on May 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of the the ignition control modual on a 1993 dodge dakota?

Inside the Computer-- on the passenger side inner fender

Only the coil is on the motor

The distributor is for injector timing,do not move it

Aug 14, 2014 | 1993 Dodge Dakota

1 Answer

How do i install my blower motor on my 1993 dodge dakota?

I had a 1992 Dakota

Is the blower not pretty much in the open, under the
dash where you can just unbolt it?

I will look in my factory manual if can't figure it out.

Jul 14, 2014 | 1993 Dodge Dakota

1 Answer

Stalling and overdrive

IAC ( idle air control ) location. You need to be sure to clean pintle (pointed end) of motor as well as spray clean inside port where it comes out of. Careful not to lose small "o" ring on motor.

Feb 27, 2014 | 1993 Dodge Dakota

1 Answer

Dodge 1993 pickup wont turn-over and no spark. i can short out starter motor turn over but no spark. changed out inition switch.

poss cam sensor inside distributor, crank sensor on top of transmission on passenger side or the ignition module inside of computer went bad!

May 18, 2011 | 1993 Dodge Dakota

1 Answer

Would a motor from a 1997 dodge dakota 3.9 fit in a 1993 dodge dakota that had a 3.9

motor may be same but you need to check if trans were built in same locale ie U.S. or ?use vin numbers and call salvage

Apr 28, 2010 | 1993 Dodge Dakota

1 Answer

Windshield wipers don't work but the motor runs . 93 Dodge Dakota

remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.

Nov 07, 2009 | 1993 Dodge Dakota

1 Answer

Need help with a dodge dakota reg cab fuse panel diagram

Hanes or
The owners little pocket operations guide

Apr 04, 2009 | 1993 Dodge Dakota

1 Answer

Will a 440 short block engine fit into a 1993

A 5.9 should fit nice with no mods

Mar 02, 2009 | 1993 Dodge Dakota

1 Answer

I need to replace the engine in my 1993 dodge dakota sport.

they came with 318 v8 its verry comon motor and should not be hard to find a used one

Mar 02, 2009 | 1993 Dodge Dakota

Not finding what you are looking for?

Open Questions:

See all 1993 Dodge Dakota Questions

1993 Dodge Dakota Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides