Question about 1996 Dodge Caravan

1 Answer

On my 96 caravan 3.3 i changed the bcm and now it turns but then it dies i try to put the bcm i took it out from van but still doing the same please tell me what could be wrong. thanks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Have you checked the cam sensor and crank sensor?

Posted on May 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1998 dodge minivan,PCM,was replaced. now door locks and rear window wiper comes on by itself while driving or parked. gas gauge will get stuck on empty line off and on. we were told can be BCM, is...


If it has something to do with the BCM , there would probably have DTC'S - diagnostic trouble codes stored , An just replace a BCM would cause more problems , same with PCM's ! These modules need to be configured and programmed . Also ,without testing no one could say for sure that the BCM is bad . That would be a guess ! Door locks locking an unlocking could be a bad switch input to the BCM . Watch this video plus part 2 and 3
Door Locks Go Crazy 1

May 04, 2017 | 1998 Dodge Caravan

1 Answer

96 Dodge Caravan ABS Battery lights stays on, radio dies, gauges drop, then restores Advice needed? Hi, I'm a bit new, so I hope you will forgive my lack of knowledge here. I have a 96 Dodge Caravan Sport...


Sounds like the BCM (body Control Module), although it could be a bad battery or alternator. Since the van keeps running ok, I'd tend towards the BCM.

Since you lose speedo and such, it's a bit dangerous to let it go too long. ;>

You can also buy a cheap dollar store light that plugs into your cigarette lighter. Make sure you can see it, but it doesn't blind you. If the light stays at about the same brightness, or gets a _little_ brighter when the gremlins attack, it's probably NOT the battery or alternator. yes, it cheesy and cheap, but I _like_ cheap troubleshooting.

Sep 01, 2010 | 1996 Dodge Caravan

2 Answers

96 t&C van rr wipers turn on my themselves and


Sounds like the Body Control Module, they are common on this van.

Apr 27, 2010 | 1997 Dodge Caravan

2 Answers

96 dodge caravan replaced starter turn key nothing


Is the van in neutral or park? How about the battery cable, did you put it back on? Is it clean? How about the battery terminals,? Clean? Anti-theft device? Just because your starter is new , doesn't mean it is good. If you can't get it to turn over the motor, take it back. Hope this helps.

Apr 07, 2010 | 1996 Dodge Caravan

1 Answer

Van starts, runs fine, then puts at low speed and dies when idled


If you have a check engine light on, than it is likely a sensor that needs to be replaced. If filter has been changed, you may have weak fuel pressure, or a bad sensor. A leaky fuel injector will also cause this

Jun 30, 2009 | 1996 Dodge Caravan

2 Answers

1999 Dodge Caravan Clockspring and BCM problems


Hold dodge accountable for 10 or more years of bad bcm's and electrical problems. Maybe there is a class action going on we can contact. I'm going to keep looking.

Jun 27, 2009 | 2001 Dodge Caravan

1 Answer

Door locks dont work


2 things I would try before replacing an expensive BCM. Disconnect your battery for 5 minutes or so, then reconnect, and see if that helped at all. I have heard in some cases it worked successfully. If that doesn't cure it, I would go to the plug on the BCM itself, (with battery disconnected) and pull the plug off, inspect it, and clean it & mating pins on BCM very thoroughly with contact cleaner or similar electrical cleaner. Add a little di-electric grease to connection & put it back together nice & tight & see what happens. The BCM is usually located on passenger side in kick panel area,(by right foot when sitting) either behind kick panel or above it.

Mar 15, 2009 | 2000 Dodge Caravan

3 Answers

1998 dodge caravan crank shaft or cam shaft sensor??


maybe have autozone or equal scan the computer for codes. could be a misfire in the cyl. somewhere. give me a code number and i will try to assist you further.

Nov 09, 2008 | 1998 Dodge Caravan

2 Answers

96 dodge grand caravan help me please


Check MAP sensor. If PCM gets wrong data from MAP sensor it should offset ignition timing and/or make fuel mixture too lean or too rich.

Nov 05, 2008 | 1996 Dodge Grand Caravan

Not finding what you are looking for?
1996 Dodge Caravan Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...