Question about 1986 Mitsubishi Montero

1 Answer

What do i need to do on a mitsubishi montero 86 2600cc to change the timing chain thank you

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 164 Answers

If you never have attempted that big of a job, don't start now. You can go buy a Haynes manual for that year car and see what it entails to do the job,,,,,,

Posted on Oct 31, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnny5846
  • 379 Answers

SOURCE: 2000 MITSUBISHI MONTERO BATTERY CHANGE

manufacturer does not provide a specific computer relearn procedure for obtaining proper driveability . if the battery was disconnected or replaced , driving the vehicle will enable the computer to preform a relearn procedure for obtaining proper driveability , driveability may differ from what you are used to until computer has fully completed the relearn procedure . cheers

Posted on Jan 09, 2009

mjvgamer
  • 7 Answers

SOURCE: how to change the fuel pump on a 1994 Mitsubishi Montero LS 3L V6

just for you REMOVAL & INSTALLATION
See Figures 1 and 2
WARNING In almost every case, replacing the Mitsubishi electric fuel pump requires removal of the fuel tank. Please refer to the fuel tank removal and installation procedure at the end of this section.

  1. Lift or move aside the carpet in the rear cargo area.
  2. Remove the oval cover plate from the access hole.
  3. Disconnect the fuel pump harness connector at the rear of the fuel tank.
  4. Start the engine, allowing it to run until it runs out of fuel. This relieves pressure within the fuel system.
  5. Turn the ignition switch OFF and disconnect the negative battery cable.
  6. Remove the fuel filler cap.
  7. Drain the fuel from the fuel tank into suitable container(s), each with an airtight lid.
  8. Carefully, and using two wrenches on the fittings, disconnect the high pressure fuel line and the main fuel line from the pump. Remove the high pressure fuel hose at the body-side main pipe connection, unfasten the pump-side connection. Wrap each joint in a rag before loosening; some pressure may remain within the system.
  9. Remove the fuel pump retaining nuts and carefully remove the pump from the tank.
The fuel pump may still contain liquid fuel. Drain it into a suitable container with an airtight lid before performing any tests or inspections.
To install:
  1. Carefully install the pump into the tank and install the 6 retaining nuts onto the studs. Tighten the nuts evenly and in a crisscross pattern to 12 ft. lbs. (16 Nm).
  2. Reinstall the high pressure and supply line to the pump.
WARNING Take great care when connecting the threaded high pressure lines. Start the threads by hand, then, while holding the hose side to keep it from turning, tighten the flare nut to 27 ft. lbs. (37 Nm).
  1. Connect the pump wiring harness.
  2. Connect the negative battery cable. Turn the ignition key to ON but do not start the engine. You should hear the pump running. Allow it to run for about 10 seconds to build line pressure, then start the engine.
  3. After the engine has run smoothly for a minute or two, shut the ignition off and check the work area for any trace of leakage. Attend to any fuel leaks immediately, remembering that the system has repressurized and must be handled safely.
  4. Reinstall the cover on the access hole and replace the carpet in the cargo area.
0900c152800547c3.jpgFig. 1: Components of the fuel pump and fuel tank 0900c152800547c4.jpgFig. 2: Components of the fuel pump-all models similarTESTING
When diagnosing engine problems, particularly a "no start" condition, the fuel pump function should be checked. Because of the difficulty in reaching the fuel pump connections, Mitsubishi automobiles have a conveniently located test connector under the hood. V6 Monteros have the connector taped to a wiring harness inside the right front kick panel, near the ECM and relays.
This connector bypasses all of the controls in the system (ignition switch, pump relay, etc.) and sends voltage directly to the pump. When power is applied to the pump you should be able to hear it running, although the in-tank pumps require you remove the fuel filler cap and listen at the filler.
To use the test connector, make certain the ignition is OFF. Great damage may be caused if the system is tested with the key on. Locate the test connector in the engine compartment (on later Monteros it is located under the right-hand side of the dashboard)-it is generally on a short lead out of a wiring harness and looks like a plug that isn't connected to anything. Once found, use a jumper wire to connect the test terminal to the positive battery terminal. Listen for the fuel pump; if it runs, you know the pump motor is good. While the pump is running, gently squeeze one of the fuel lines and confirm that the pump is delivering fuel pressure. If it does not run, the pump itself is most likely defective OR the connector to the pump is faulty.
When the pump is removed from the tank, it may be checked by applying battery voltage (+) to the connector and grounding the housing. Only run the pump for one or two seconds during this test; the pump can be damaged by running without liquid.
CAUTION Make certain the pump has been drained of residual fuel and is free of fuel vapors. Connecting and removing the test leads will cause sparks which can ignite any vapor in the area.

Posted on Jan 18, 2009

ewashmidas
  • 362 Answers

SOURCE: Timing belt for 2000 Mitsubishi Montero Sport

Mitsubishi wants the belt changed every 60,000 miles. If there is any doubt, change it.

Posted on Jan 31, 2009

  • 1 Answer

SOURCE: mitsubishi montero radio unlock

i tried to many codes for the radio lock and now it just says off. how to is fix it?

Posted on Feb 08, 2009

rockitman187
  • 2559 Answers

SOURCE: asistance to change the thermostat in a 2002 mitsubishi montero limited

Follow the top radiator hose down to the water outlet. The thermostat is inside the water outlet,Just remove the bolts,replace thermostat,replace gasket,bolt back in place.

Posted on May 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

If the timing belt tensioner goes bad will it make a knocking sound on a 2002 Mitsubishi Montero Sport


Lol absolutely. It will knock if bad on any car. Need to replace it and the timing belt/chain asap. If not you will kill the engine.

Mar 01, 2017 | 2002 Mitsubishi Montero

1 Answer

What type of transmission fluid do i need for a 1998 mitsubitshi montero sport v6?


Hi there:On 1998 Mitsubishi Truck Montero Sport 4WD 3.0L MFI 6cyl check this Transmission Fluid Type/Capacity information:
Application: With automatic transmission

AW30-40LE transService change only - 2.3 quarts. Total refill - 10.4 quarts.



Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jun 28, 2012 | 1998 Mitsubishi Montero Sport

1 Answer

What is the proper timing chain tension for 1987 Mitsubishi Montero 2.6 l


The chain is automatically tensioned, no adjustment is necessary, if it is noisy then the chain or the tensioner are worn out.

Feb 13, 2012 | 1987 Mitsubishi Montero

1 Answer

Would my timing chain on a 92 4cyl magna have an adjustable timing chain


no, once the chain is set there is no way to change it, unless you take it off and install a new one.The timing chain has tensioners that keep the tension by itself.I hope I could help rate me accordingly, Thanks!!

Oct 11, 2010 | 1992 Mitsubishi Montero

2 Answers

Replacing cylinder head on 1986 montero with 2.6 timing chain. just need timing marks and head torque specs.


ok
42011354
  1. Torque all bolts except No. 11 to 69 ft. lbs. on a cold engine or 75 ft. lbs. on a hot engine.
  2. Torque cylinder head to chain case cover bolts (No. 11) to 156 inch lbs.
  3. 42011356

Sep 17, 2009 | 1986 Mitsubishi Montero

1 Answer

My 99 montero broke its timing chain what kind of damage dos that cause,,thanks


typically there shouldnt be any damage to the vehicle.

just get the timing chain fixed and you can get going.

Aug 05, 2009 | 1999 Mitsubishi Montero Sport

1 Answer

2004 Mitsubishi Montero Sport LS 65,000Miles. My belts seem to make a lot of annoying, loud sound. Especially after it rains. Is this a timing belt/chain issue or one of the other belts?


I have a 98 Montero Sport, whenever my belt sqeaks I check the tension and usually thats the problem. Tighten them accordingly and it should solve it. As for the timing belt, mine is a belt not chain. First time I had it changed was at 100,000 miles and the dealrship said I was cutting it close ><

Jun 06, 2009 | 2004 Mitsubishi Montero Sport

1 Answer

How to time a mitsubishi montero


Hi,well the way you are saying about timing what size engine is it? if its a 2.8 they run on a timing chain which requires no attention,if its a 2.5 then we are talking about changing a timing belt and kit.please could you give me more information on this.
hope this helps.
George.

Apr 19, 2009 | 1995 Mitsubishi Montero

1 Answer

Timing belt for 2000 Mitsubishi Montero Sport


Mitsubishi wants the belt changed every 60,000 miles. If there is any doubt, change it.

Sep 12, 2008 | 2000 Mitsubishi Montero Sport

1 Answer

Pajero


No, timing chains are not expected to be replaced periodically like belts. Ocassionally they get noisey at high mileages and require a new tensioner pad but usually the chain is OK with a new pad

Jun 27, 2008 | 2002 Mitsubishi Montero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...